Search results
Results from the WOW.Com Content Network
The 2N3906 is a commonly used PNP bipolar junction transistor intended for general purpose low-power amplifying or switching applications. [1] [2] It is designed for low electric current and power and medium voltage, and can operate at moderately high speeds. It is complementary to the 2N3904 NPN transistor. [3]
The output is usually connected to an external pull-up resistor, which pulls the output voltage to the resistor's supply voltage when the transistor is off. For PNP open collector outputs, the emitter of the PNP transistor is internally connected to the positive voltage rail, so the collector outputs a high voltage when the transistor is on or ...
A typical use of these transistors is as a switch for moderate voltages and currents, including as drivers for small lamps, motors, and relays. [1] In switching circuits, these FETs can be used much like bipolar junction transistors, but have some advantages: high input impedance of the insulated gate means almost no gate current is required
The 2N3904 is a common NPN bipolar junction transistor used for general-purpose low-power amplifying or switching applications. [1] [2] [3] It is designed for low current and power, medium voltage, and can operate at moderately high speeds. It is complementary to the 2N3906 PNP transistor. Both types were registered by Motorola Semiconductor in ...
Diode–transistor logic (DTL) is a class of digital circuits that is the direct ancestor of transistor–transistor logic. It is called so because the logic gating functions AND and OR are performed by diode logic , while logical inversion (NOT) and amplification (providing signal restoration) is performed by a transistor (in contrast with ...
Figure 3: PNP version of the emitter-follower circuit, all polarities are reversed. A small voltage change on the input terminal will be replicated at the output (depending slightly on the transistor's gain and the value of the load resistance; see gain formula below). This circuit is useful because it has a large input impedance
Efficiency is mediocre because single npn-type transistors or Darlington pairs require fairly a high collector-emitter voltage drop. [28] A single common-emitter pnp-type transistor can operate correctly in saturation mode, with only ≈0.25 V voltage drop, but also with impractically high base currents. [29]
The 2N2907 is a commonly available PNP bipolar junction transistor used for general purpose low-power amplifying or switching applications. It is designed for low to medium current, low power, medium voltage, and can operate at moderately high speeds.