Search results
Results from the WOW.Com Content Network
Hydrogen pipeline transport is a transportation of hydrogen through a pipe as part of the hydrogen infrastructure. Hydrogen pipeline transport is used to connect the point of hydrogen production or delivery of hydrogen with the point of demand, pipeline transport costs are similar to CNG, [9] the technology is proven, [10] however most hydrogen is produced on the place of demand with every 50 ...
The Kawasaki triples were a range of 250 to 750 cc (15 to 46 cu in) motorcycles made by Kawasaki from 1968 to 1980. The engines were air-cooled, three-cylinder, piston-controlled inlet port two-strokes with two exhaust pipes exiting on the right side of the bike, and one on the left.
Hydrogen has a wide flammability range (3–70% H 2 in air) in comparison with other fuels. [35] As a result, it can be combusted in an internal combustion engine over a wide range of fuel-air mixtures. An advantage of this is the engine can be run using a lean fuel-air mixture.
It can also enter pipes and can follow them to their destinations. Because of this, hydrogen pipes should be well-labeled and located above other pipes to prevent this occurrence. [10] [16] Even with proper design, hydrogen leaks can support combustion at very low flow rates, as low as 4 micrograms/s. [1] [35] [12] To this end, detection is ...
In September 1971 the H2 was a direct result of the success of the 500 cc Kawasaki H1 Mach III introduced in 1969. The H2 engine was a 3-cylinder two-stroke with an engine displacement of 748 cc (45.6 cubic inches) which produced 74 horsepower (55 kW) at 6,800 rpm, a power-to-weight ratio of 1 hp (0.75 kW) to every 5.7 lb (2.6 kg) of weight.
The storage cylinders may be used independently in sequence using a portable transfer whip with a pressure gauge and manual bleed valve, to transfill the receiving cylinder until the appropriate fill pressure has been reached, or the storage cylinders may be connected to a manifold system and a filling control panel with one or more filling whips.
The pipe incorporates an outer jacket that shrouds the inner high pressure pipe. This jacket is usually metallic in construction and can either be a thin walled tube or convoluted hose. In the event of a burst in the injection pipe the leaking fuel will be collected by the jacket and piped away safely to an alarm device to notify operators of a ...
Pipe is generally manufactured to one of several international and national industrial standards. [1] While similar standards exist for specific industry application tubing, tube is often made to custom sizes and a broader range of diameters and tolerances. Many industrial and government standards exist for the production of pipe and tubing.