enow.com Web Search

  1. Ads

    related to: direct conversion flat panel detectors indoor

Search results

  1. Results from the WOW.Com Content Network
  2. Flat-panel detector - Wikipedia

    en.wikipedia.org/wiki/Flat-panel_detector

    A portable aSi flat-panel detector is used to visualise the movement of liquids in sand cores under high pressure. Flat-panel detectors are a class of solid-state x-ray digital radiography devices similar in principle to the image sensors used in digital photography and video. They are used in both projectional radiography and as an alternative ...

  3. Digital radiography - Wikipedia

    en.wikipedia.org/wiki/Digital_radiography

    Flat panel detectors (FPDs) are the most common kind of direct digital detectors. [2] They are classified in two main categories: 1. Indirect FPDs Amorphous silicon (a-Si) is the most common material of commercial FPDs. Combining a-Si detectors with a scintillator in the detector’s outer layer, which is made from caesium iodide (CsI) or ...

  4. X-ray detector - Wikipedia

    en.wikipedia.org/wiki/X-ray_detector

    X-ray detectors are devices used to measure the flux, spatial distribution, spectrum, and/or other properties of X-rays. Detectors can be divided into two major categories: imaging detectors (such as photographic plates and X-ray film (photographic film), now mostly replaced by various digitizing devices like image plates or flat panel ...

  5. Fluoroscopy - Wikipedia

    en.wikipedia.org/wiki/Fluoroscopy

    Nowadays, in all forms of digital X-ray imaging (radiography, fluoroscopy, and CT) the conversion of X-ray energy into visible light can be achieved by the same types of electronic sensors, such as flat panel detectors, which convert the X-ray energy into electrical signals: small bursts of electric current that convey information that a ...

  6. Direct-conversion receiver - Wikipedia

    en.wikipedia.org/wiki/Direct-conversion_receiver

    Direct-conversion receiver. A direct-conversion receiver (DCR), also known as homodyne, synchrodyne, or zero-IF receiver, is a radio receiver design that demodulates the incoming radio signal using synchronous detection driven by a local oscillator whose frequency is identical to, or very close to the carrier frequency of the intended signal.

  7. Photostimulated luminescence - Wikipedia

    en.wikipedia.org/wiki/Photostimulated_luminescence

    Photostimulated luminescence (PSL) is the release of stored energy within a phosphor by stimulation with visible light, to produce a luminescent signal. X-rays may induce such an energy storage. A plate based on this mechanism is called a photostimulable phosphor (PSP) plate (or imaging plate) and is one type of X-ray detector used in ...

  8. Industrial radiography - Wikipedia

    en.wikipedia.org/wiki/Industrial_radiography

    Industrial radiography is a modality of non-destructive testing that uses ionizing radiation to inspect materials and components with the objective of locating and quantifying defects and degradation in material properties that would lead to the failure of engineering structures. It plays an important role in the science and technology needed ...

  9. Radio receiver design - Wikipedia

    en.wikipedia.org/wiki/Radio_receiver_design

    In the Direct conversion receiver, the signals from the antenna are only tuned by a single tuned circuit before entering a mixer where they are mixed with a signal from a local oscillator which is tuned to the carrier wave frequency of the transmitted signal. This is unlike the superheterodyne design, where the local oscillator is at an offset ...

  1. Ads

    related to: direct conversion flat panel detectors indoor