enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

3. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   The tapped hole (or nut) into which the screw fits, has an internal diameter which is the size of the screw minus the pitch of the thread. Thus, an M6 screw, which has a pitch of 1 mm, is made by threading a 6 mm shank, and the nut or threaded hole is made by tapping threads into a hole of 5 mm diameter (6 mm − 1 mm).

4. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   Robertson screw. A Robertson screw, also known as a square screw[1] or Scrulox, [2] is a type of screw with a square -shaped socket in the screw head and a corresponding square protrusion on the tool. Both the tool and socket have a slight taper. The contemporary square drive screw has all but replaced the Robertson screw proper and is commonly ...

5. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

6. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The outermost 1 ⁄ 8 and the innermost 1 ⁄ 4 of the height H of the V-shape are cut off from the profile. The major diameter D maj is the diameter of the screw measured from the outer edge of the threads. The minor diameter D min (also known as the root diameter) is the diameter of the screw measured from the inner edge of the threads. The ...

7. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   The #6-32 UNC screw has a thread pitch of 1/32 in (0.031250 inches (0.7938 mm)).. The #6-32 UNC is a UTS screw specifying a major thread diameter of #6 which is defined as 0.1380 inches (3.51 mm); and 32 tpi (threads per inch) which equates to a thread pitch of 0.031250 inches (0.7938 mm).