enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Caliber conversion device - Wikipedia

   en.wikipedia.org/wiki/Caliber_conversion_device

   The most commonly encountered supplemental chambers are for .30 caliber rifles designed for .308-inch (7.8 mm) diameter bullets, to use .32 caliber handgun cartridges with bullet diameters of approximately .312-inch (7.9 mm). Cartridge adapters have also been made to use .38 caliber handgun cartridges with bullet diameters of approximately .357 ...

3. 4.3-10 connector - Wikipedia

   en.wikipedia.org/wiki/4.3-10_connector

   universal support for hex-wrench, hand-tighten and quick-release couplings; The footprint was decreased by reducing the outer conductor diameter from 16 to 10 mm, which lowers the power rating, but allows a connection density of 1 connector per inch (2.54 cm), in line with other connectors such as DIN 4.1/9.5 or N connectors. [3]

4. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

5. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 10 mm for a M10×1.5 tap), and pitch is the pitch of the thread (1.5 mm in the case of a standard M10 tap) and so the correct drill size is 8.5 mm. This works for both fine and coarse pitches, and also produces an approximate 75% thread.

6. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.

7. Adjustable spanner - Wikipedia

   en.wikipedia.org/wiki/Adjustable_spanner

   An adjustable spanner (UK and most other English-speaking countries), also called a shifting spanner (Australia and New Zealand) [1] or adjustable wrench (US and Canada), [a] is any of various styles of spanner (wrench) with a movable jaw, allowing it to be used with different sizes of fastener head (nut, bolt, etc.) rather than just one fastener size, as with a conventional fixed spanner.