Search results
Results from the WOW.Com Content Network
[39] [40] [23] The FMEA worksheet is hard to produce, hard to understand and read, as well as hard to maintain. The use of neural network techniques to cluster and visualise failure modes were suggested starting from 2010. [41] [42] [43] An alternative approach is to combine the traditional FMEA table with set of bow-tie diagrams. The diagrams ...
Generally, beyond a certain angle (usually around 45 degrees), the surface doesn't require support. Overhang base: Increase section thickness at base to avoid tearing. Avoid sharp transitions at overhang base. Air pocket releaf: Without supports, printing parts with a flat surface and holes in the geometry may create air bubbles. As the part ...
If a gaseous emission sample is analyzed and found to contain water vapor and a pollutant concentration of say 40 ppmv, then 40 ppmv should be designated as the "wet basis" pollutant concentration. The following equation can be used to correct the measured "wet basis" concentration to a " dry basis " concentration: [ 3 ]
Non-contact atomic force microscopy (nc-AFM), also known as dynamic force microscopy (DFM), is a mode of atomic force microscopy, which itself is a type of scanning probe microscopy. In nc-AFM a sharp probe is moved close (order of Angstroms ) to the surface under study, the probe is then raster scanned across the surface, the image is then ...
Thus the standard consists of a tabulation of values at various altitudes, plus some formulas by which those values were derived. To allow modeling conditions below mean sea level , the troposphere is actually extended to −2,000 feet (−610 m), where the temperature is 66.1 °F (18.9 °C), pressure is 15.79 pounds per square inch (108,900 Pa ...
Duct slopes level to 30 degrees, 25% of cross section. Duct slopes, 30 degrees to 45 degrees, 15% of cross section; Duct Slopes, 45 degrees to 85 Degrees, 5%; Above 85 degrees, a 2 in (50 mm) interior coating of dust. These loads are always confirmed with the client, before use, but the above in US common practice
However, support structures are explicitly required for most of the downward facing surfaces that make an angle less than 45 degrees with the powder bed. This is because powder bed alone is insufficient to hold the liquid phase of the metal that is created when laser is scanning the powder. Support structures are also required to restrict ...
Rule based DFM analysis for forging is the controlled deformation of metal into a specific shape by compressive forces. The forging process goes back to 8000 B.C. and evolved from the manual art of simple blacksmithing. Then as now, a series of compressive hammer blows performs the shaping or forging of the part. Modern forging uses machine ...