Search results
Results from the WOW.Com Content Network
Lockout Tagout hasp can accommodate up to 6 padlocks, can be used during group LOTO procedure. Lock out, tag out or lockout–tagout (LOTO) is a safety procedure used to ensure that dangerous equipment is properly shut off and not able to be started up again prior to the completion of maintenance or repair work.
Installation of a double-walled copper-on-copper heat exchanger in a vertical section of the master drain line in a Canadian home (2007) Water heat recycling (also known as drain water heat recovery, waste water heat recovery, greywater heat recovery, [citation needed] or sometimes shower water heat recovery [citation needed]) is the use of a heat exchanger to recover energy and reuse heat ...
Water chlorination is the process of adding chlorine or chlorine compounds such as sodium hypochlorite to water. This method is used to kill bacteria, viruses and other microbes in water. This method is used to kill bacteria, viruses and other microbes in water.
Two drops of 5% solution also suffices. Double the amount of bleach if the water is cloudy, colored, or very cold. Afterwards, the water should have a slight chlorine odor. If not repeat the dosage and let stand for another 15 minutes before use. After this treatment, the water may be left open to reduce the chlorine smell and taste. [22] [6]
Salt water chlorination is a process that uses dissolved salt (1000–4000 ppm or 1–4 g/L) for the chlorination of swimming pools and hot tubs.The chlorine generator (also known as salt cell, salt generator, salt chlorinator, or SWG) uses electrolysis in the presence of dissolved salt to produce chlorine gas or its dissolved forms, hypochlorous acid and sodium hypochlorite, which are already ...
In Cyprus and Israel 90 percent of homes have solar water heating systems. [3] The most basic solar thermal models are the direct-gain type, in which the potable water is directly sent into the collector. Many such systems are said to use integrated collector storage (ICS), as direct-gain systems typically have storage integrated within the ...
The water used is usually brackish water or brine (i.e. a solution with >0.5% salinity). In these cases, additional contaminant chemicals may be present in the water feed. The low voltage DC current still performs electrochlorination. The excess chemicals are left untouched and can be easily discarded. [2]
The grade of chlorine-based bleaches is often expressed as percent active chlorine. One gram of 100% active chlorine bleach has the same bleaching power as one gram of elemental chlorine. The most common chlorine-based bleaches are: Sodium hypochlorite (NaClO), usually as a 3–6% solution in water, usually called "liquid bleach" or just "bleach".