Search results
Results from the WOW.Com Content Network
In electronic logic circuits, a pull-up resistor (PU) or pull-down resistor (PD) is a resistor used to ensure a known state for a signal. [1] It is typically used in combination with components such as switches and transistors , which physically interrupt the connection of subsequent components to ground or to V CC .
There is nothing special about pull-up or pull-down resistors, it's just how the resistors are connected in a circuit. The voltage drop across any resistor depends on the current flowing; in a circuit, currents can change and consequently the voltages at specific points in that circuit may go up at one end of what is called a pull-up resistor ...
−20%, or for components with uncritical values such as pull-up resistors. The calculated constant tangential tolerance for this series gives (3 √ 10 − 1) ÷ (3 √ 10 + 1) = 36.60%, approximately. While the standard only specifies a tolerance greater than 20%, other sources indicate 40% or 50%.
Variable resistors can be used to adjust circuit elements (such as a volume control or a lamp dimmer), or as sensing devices for heat, light, humidity, force, or chemical activity. Resistors are common elements of electrical networks and electronic circuits and are ubiquitous in electronic equipment. Practical resistors as discrete components ...
The high-impedance state of a given node in a circuit cannot be verified by a voltage measurement alone. A pull-up resistor (or pull-down resistor) can be used as a medium-impedance source to try to pull the wire to a high (or low) voltage level. If the node is not in a high-impedance state, extra current from the resistor will not ...
Pull-up resistors are provided by the I3C controller. External pull-up resistors are no longer needed. Clock Stretching – devices are expected to be fast enough to operate at bus speed. The I3C controller is the sole clock source. I²C Extended (10-bit) Addresses. All devices on an I3C bus are addressed by a 7-bit address.
From Wikipedia, the free encyclopedia. Redirect page
An active-low OR diode logic gate is formed by a keypad containing diodes at each switch, all connected to a shared pull-up resistor. When no switch is closed, the pull-up keeps the output high. But when the switch for any key connects to ground, the output goes low. This OR result can be used as an interrupt signal to indicate that any key has ...