Search results
Results from the WOW.Com Content Network
The Intel 8085 ("eighty-eighty-five") is an 8-bit microprocessor produced by Intel and introduced in March 1976. [2] It is the last 8-bit microprocessor developed by Intel. It is software-binary compatible with the more-famous Intel 8080 with only two minor instructions added to support its added interrupt and serial input/output features.
The instruction set architecture (ISA) that the computer final version (SAP-3) is designed to implement is patterned after and upward compatible with the ISA of the Intel 8080/8085 microprocessor family. Therefore, the instructions implemented in the three SAP computer variations are, in each case, a subset of the 8080/8085 instructions. [2]
The Intel 8080 ("eighty-eighty") is the second 8-bit microprocessor designed and manufactured by Intel. It first appeared in April 1974 and is an extended and enhanced variant of the earlier 8008 design, although without binary compatibility . [ 3 ]
IMSAI VDP-40 desktop computer of 1977-1979. Intel 8085, 32/64KB RAM, 2× FDD 80/160KB, S-100 bus. 2KB monitor ROM, 2KB Video ROM. The IMSAI 8080 is an early microcomputer released in late 1975, based on the Intel 8080 (and later 8085) and S-100 bus. [1] It is a clone of its main competitor, the earlier MITS Altair 8800. The IMSAI is largely ...
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
The 8086 [3] (also called iAPX 86) [4] is a 16-bit microprocessor chip designed by Intel between early 1976 [citation needed] and June 8, 1978, when it was released. [5] The Intel 8088, released July 1, 1979, [6] is a slightly modified chip with an external 8-bit data bus (allowing the use of cheaper and fewer supporting ICs), [note 1] and is notable as the processor used in the original IBM ...
The 8259 may be configured to work with an 8080/8085 or an 8086/8088. On the 8086/8088, the interrupt controller will provide an interrupt number on the data bus when an interrupt occurs. The interrupt cycle of the 8080/8085 will issue three bytes on the data bus (corresponding to a CALL instruction in the 8080/8085 instruction set).
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.