Search results
Results from the WOW.Com Content Network
For instance, .001 of an inch worn off of the engine's main bearings can cause up to a 20% loss in oil pressure. [6] Simply replacing worn bearings may fix this problem, but in older engines with a lot of wear not much can be done besides completely overhauling the engine. Particles in the oil can also cause serious problems with oil pressure.
Also, in the fall of 1998, GM introduced the C/K crew cab with the 6.5' bed. It was available in the 2500 or 3500 series and two- or four-wheel drive. The 2500 series was available with the 5.7L or 7.4L V8 gasoline engine, or the 6.5L V8 diesel engine, and came with a GVWR of 8,600 pounds.
Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...
Chevrolet 153 Inline 4 (Chevy II, pre-Iron-Duke - includes the Vortec 3000/181 industrial/marine crate motor) Detroit Diesel V8 6.2L and 6.5L; Duramax V8; Generation III V8s with modifications. These modifications include an additional bolt hole at the top of the pattern, and attachment points for cast oil pans to lower bellhousing extensions ...
As GM entered the 1990s, the company revised its truck ranges, replacing the medium-duty C/K trucks with the Chevrolet Kodiak/GMC TopKick for 1990. For 1999, GM replaced the fourth-generation C/K pickup trucks with an all-new model line; in line with GMC, Chevrolet dropped the C/K nameplate (in favor of a singular Chevrolet Silverado nameplate).
The GMT 400 and similar GMT 480 was the platform used for the Chevrolet C/K and GMC Sierra full-size pickup trucks beginning with the 1988 model year. [1] The GMT 410, GMT 420, GMT 425, and GMT 430 variants were derived for full-size SUVs, including the 1992–1994 Chevrolet Blazer and 1995–2000 Tahoe, and the GMC Yukon from late 1991 to 2000.
The General Motors ignition switch recalls refers to February 6, 2014 when General Motors recalled about 800,000 of its small cars due to faulty ignition switches, which could shut off the engine while the vehicle was in motion and thereby prevent the airbags from inflating. [1]
The 90° V6 engine uses the same transmission bellhousing pattern as the Chevrolet small-block V8 engine. The oil pan dipstick is located on the passenger side above the oil pan rail; this design was phased in on both the 90° V6 and Small Block Chevrolet assembly lines (for engines manufactured after 1979) sharing the same casting dies.