Search results
Results from the WOW.Com Content Network
The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed worldwide. The test procedure is described in ISO 22476-3, ASTM D1586 [1] and Australian Standards AS ...
The test method consists of pushing an instrumented cone, with the tip facing down, into the ground at a controlled rate (controlled between 1.5 -2.5 cm/s accepted). The resolution of the CPT in delineating stratigraphic layers is related to the size of the cone tip, with typical cone tips having a cross-sectional area of either 10 or 15 cm 2 ...
The CBR test is a penetration test in which a standard piston, with a diameter of 50 mm (1.969 in), is used to penetrate the soil at a standard rate of 1.25 mm/minute. Although the force increases with the depth of penetration, in most cases, it does not increase as quickly as it does for the standard crushed rock, so the ratio decreases.
STRIDE is a model for identifying computer security threats [1] developed by Praerit Garg and Loren Kohnfelder at Microsoft. [2] It provides a mnemonic for security threats in six categories.
In the drilling industry, the rate of penetration (ROP), [1] also known as penetration rate or drill rate, is the speed at which a drill bit breaks the rock under it to deepen the borehole. It is normally measured in feet per minute or meters per hour, but sometimes it is expressed in minutes per foot.
Test materials can be damaged if compatibility is not ensured. The operator or their supervisor should verify compatibility on the tested material, especially when considering the testing of plastic components and ceramics. The method is unsuitable for testing porous ceramics. Penetrant stains clothes and skin and must be treated with care
A gray box penetration test is a combination of the two (where limited knowledge of the target is shared with the auditor). [6] A penetration test can help identify a system's vulnerabilities to attack and estimate how vulnerable it is. [7] [5] Security issues that the penetration test uncovers should be reported to the system owner. [8]
The Rockwell hardness test is a hardness test based on indentation hardness of a material. The Rockwell test measures the depth of penetration of an indenter under a large load (major load) compared to the penetration made by a preload (minor load). [1] There are different scales, denoted by a single letter, that use different loads or indenters.