Search results
Results from the WOW.Com Content Network
Membrane distillation (MD) is a thermally driven separation process in which separation is driven by phase change. A hydrophobic membrane presents a barrier for the liquid phase , allowing the vapour phase (e.g. water vapour) to pass through the membrane's pores. [ 1 ]
Generally, dead-end filtration is used for feasibility studies on a laboratory scale. The dead-end membranes are relatively easy to fabricate which reduces the cost of the separation process. The dead-end membrane separation process is easy to implement and the process is usually cheaper than cross-flow membrane filtration.
Membrane distillation combines membrane separation and distillation, with hydrophobic membranes and differences in vapour pressure. The Vacuum Multi Effect Membrane Distillation (VMEMD) configuration used in Aquaver systems adds the advantages of low-temperature operation and multi-effects to the membrane distillation characteristics.
A McCabe–Thiele diagram for the distillation of a binary (two-component) feed is constructed using the vapor-liquid equilibrium (VLE) data—which is how vapor is concentrated when in contact with its liquid form—for the component with the lower boiling point. Figure 1: Typical McCabe–Thiele diagram for distillation of a binary feed
The configuration of this stack can be either horizontal or vertical. The feed water passes in parallel through all the cells, providing a continuous flow of permeate and brine. Although this is a well-known process electrodialysis is not commercially suited for seawater desalination, because it can be used only for brackish water (TDS < 1000 ...
Packed bed and fluidized bed membrane reactors. Generally, membrane reactors can be classified based on the membrane position and reactor configuration. [1] Usually there is a catalyst inside: if the catalyst is installed inside the membrane, the reactor is called catalytic membrane reactor (CMR); [1] if the catalyst (and the support) are packed and fixed inside, the reactor is called packed ...
The membrane assembly consists of a pressure vessel with a membrane that allows feedwater to be pushed against it. The membrane must be strong enough to withstand the pressure. RO membranes are made in a variety of configurations. The two most common are spiral-wound and hollow-fiber. Only part of the water pumped onto the membrane passes through.
The condensate is usually withdrawn intermittently having products or cuts of different concentrations. Batch distillation is used when the feed rate is not large enough to justify installation of a continuous distillation unit. It may also be used when the constituents greatly differ in volatility. [8] [9] Figure 1 show the batch distillation ...