Search results
Results from the WOW.Com Content Network
Rate of transpiration can be influenced by factors including plant type, soil type, weather conditions and water content, and also cultivation practices. [6]: Ch. 1, "Transpiration" Evapotranspiration is typically measured in millimeters of water (i.e. volume of water moved per unit area of the Earth's surface) in a set unit of time. [6]:
Monthly estimated potential evapotranspiration and measured pan evaporation for two locations in Hawaii, Hilo and Pahala. Potential evapotranspiration is usually measured indirectly, from other climatic factors, but also depends on the surface type, such as free water (for lakes and oceans), the soil type for bare soil, and also the density and diversity of vegetation.
E = Mass water evapotranspiration rate (g s −1 m −2) ET = Water volume evapotranspired (mm s −1) Δ = Rate of change of saturation specific humidity with air temperature. (Pa K −1) R n = Net irradiance (W m −2), the external source of energy flux G = Ground heat flux (W m −2), usually difficult to measure c p = Specific heat ...
The Penman equation describes evaporation (E) from an open water surface, and was developed by Howard Penman in 1948. Penman's equation requires daily mean temperature, wind speed, air pressure, and solar radiation to predict E. Simpler Hydrometeorological equations continue to be used where obtaining such data is impractical, to give comparable results within specific contexts, e.g. humid vs ...
Given the limited data input to the equation, the calculated evapotranspiration should be regarded as only broadly accurate. Rather than a precise measure of evapotranspiration, the output of the equation is better thought of as providing an order of magnitude. [2] The inaccuracy of the equation is exacerbated by extreme variants of weather.
It is a steel container 1.83 m (6 ft) on a side and 0.61 m (2 ft) deep, sunk into the ground with an above-ground rim of 7.6–10 centimetres (3.0–3.9 in) and is painted black internally. Its evaporation rate is lower than the Class A pan and conversion factors must be used. [8]
Crop coefficients are properties of plants used in predicting evapotranspiration (ET). The most basic crop coefficient, K c, is simply the ratio of ET observed for the crop studied over that observed for the well calibrated reference crop under the same conditions.
Inputs to SPEI datasets can include high-resolution potential evapotranspiration (PET) from the Global Land Evaporation Amsterdam Model (GLEAM) and hourly Potential Evapotranspiration (hPET). GLEAM is a set of algorithms designed to calculate actual evaporation, PET, evaporative stress, and root-zone soil moisture. [5]