Search results
Results from the WOW.Com Content Network
In physics the strain rate is generally defined as the derivative of the strain with respect to time. Its precise definition depends on how strain is measured. The strain is the ratio of two lengths, so it is a dimensionless quantity (a number that does not depend on the choice of measurement units). Thus, strain rate has dimension of inverse ...
Orifice plate showing vena contracta. An orifice plate is a thin plate with a hole in it, which is usually placed in a pipe. When a fluid (whether liquid or gaseous) passes through the orifice, its pressure builds up slightly upstream of the orifice [1] but as the fluid is forced to converge to pass through the hole, the velocity increases and the fluid pressure decreases.
The beam diameter or beam width of an electromagnetic beam is the diameter along any specified line that is perpendicular to the beam axis and intersects it. Since beams typically do not have sharp edges, the diameter can be defined in many different ways. Five definitions of the beam width are in common use: D4σ, 10/90 or 20/80 knife-edge, 1 ...
= 4.1 R-0.21 mm −1 (equivalent to 41 R-0.21 cm −1 in the reference [4]), R being the rainrate in stratiform precipitation in millimeters per hour; D = raindrop diameter in mm The units of N 0 are sometimes simplified to cm −4 but this removes the information that this value is calculated per cubic meter of air.
760 mm (2 ft 5 + 15 ⁄ 16 in) Two foot six inch: ... The two points ... The rate of change of cant is used to determine the suitable cant gradient for a given design ...
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
Arc lengths are denoted by s, since the Latin word for length (or size) is spatium. In the following lines, r {\displaystyle r} represents the radius of a circle , d {\displaystyle d} is its diameter , C {\displaystyle C} is its circumference , s {\displaystyle s} is the length of an arc of the circle, and θ {\displaystyle \theta } is the ...
Bernoulli's principle can be used to calculate the lift force on an airfoil, if the behaviour of the fluid flow in the vicinity of the foil is known. For example, if the air flowing past the top surface of an aircraft wing is moving faster than the air flowing past the bottom surface, then Bernoulli's principle implies that the pressure on the ...