Search results
Results from the WOW.Com Content Network
A permanent magnet synchronous generator is a generator where the excitation field is provided by a permanent magnet instead of a coil. The term synchronous refers here to the fact that the rotor and magnetic field rotate with the same speed, because the magnetic field is generated through a shaft-mounted permanent magnet mechanism, and current is induced into the stationary armature.
The sequence of events is similar for manual or automatic synchronization. The generator is brought up to approximate synchronous speed by supplying more energy to its shaft - for example, opening the valves on a steam turbine, opening the gates on a hydraulic turbine, or increasing the fuel rack setting on a diesel engine.
During this period the rotor moves at synchronous speed ω s in rad/s. The electric torque T e corresponds to the net air-gap power in the machine and thus accounts for the total output power of the generator plus I 2 R losses in the armature winding. The angular position θ is measured with a stationary reference frame.
In a synchronous generator, [1] the short circuit ratio is the ratio of field current required to produce rated armature voltage at the open circuit to the field current required to produce the rated armature current at short circuit. [1] [2] This ratio can also be expressed as an inverse of the saturated [3] direct-axis synchronous reactance ...
The flux linkages of the generator vary with its state. Three states are considered: [5] the steady-state is the normal operating condition with the armature magnetic flux going through the rotor; the sub-transient state is the one the generator enters immediately after the fault (short circuit). In this state the armature flux is pushed ...
The name "synchronous impedance curve" is due to the fact that in the short-circuit condition all the generated voltage dissipates across the generator internal synchronous impedance . [ 2 ] The curve is obtained by rotating the generator at the rated RPM with the output terminals shorted and the output current going to 100% of the rated for ...
Droop speed control is a control mode used for AC electrical power generators, whereby the power output of a generator reduces as the line frequency increases. It is commonly used as the speed control mode of the governor of a prime mover driving a synchronous generator connected to an electrical grid. It works by controlling the rate of power ...
A diagram with multiple synchronous machine curves; open-circuit saturation curve is the leftmost one The open-circuit saturation curve (also open-circuit characteristic, OCC) of a synchronous generator is a plot of the output open circuit voltage as a function of the excitation current or field.