enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ring binder - Wikipedia

   en.wikipedia.org/wiki/Ring_binder

   There is a variant for half-letter size pages (8 + 1 ⁄ 2 by 5 + 1 ⁄ 2 inches or 220 mm × 140 mm), whose three rings are 2 + 3 ⁄ 4 inches (70 mm) apart. "Ledger" size binders hold 11-by-17-inch (28 by 43 cm) paper, and may use standard 3-ring spacing or multiple additional rings.

3. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   Then the user chooses a spine size that will match the document. Standard sizes are 4.8 mm ( 3 ⁄ 16 in) (for 16 sheets of 20# paper) up to 51 mm (2 in) (for 425 sheets). Spine lengths are generally 280 mm (11 in) to match the length of letter-size paper.

4. Wire binding - Wikipedia

   en.wikipedia.org/wiki/Wire_binding

   It is most commonly found in sizes from 16 mm (5 ⁄ 8 in) to 32 mm (1 + 1 ⁄ 4 in). However, a couple of manufacturers make special small sizes, with diameters down to 6.4 mm ( 1 ⁄ 4 in). Renz GmbH own the registered trademark for One Pitch®, which is a brand describing 1/4" to 1/2" sizes.

5. Loose leaf - Wikipedia

   en.wikipedia.org/wiki/Loose_leaf

   In North America, 3-hole binders for letter-size papers typically have a width of 1/2 inch, 1 inch, 1.5 inches, 2 inches, 3 inches or 4 inches; in ISO system, binders typically have a width of less than 3 cm. “Discbound” loose leaf systems, which uses separate “discs” to hold covers and pages. Staples and Office Depot sell discbound ...

6. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   The holes are positioned symmetrically, with the centers 4 + 1 ⁄ 4 inches (108 mm) apart. It requires paper formats that are at least 9 + 1 ⁄ 2 inches (241 mm) high. There is a variant for half-letter size pages (8 + 1 ⁄ 2 by 5 + 1 ⁄ 2 inches or 220 mm × 140 mm), whose three holes are 2 + 3 ⁄ 4 inches (70 mm) apart.

7. Binder clip - Wikipedia

   en.wikipedia.org/wiki/Binder_clip

   There are several sizes of binder clips, ranging from a base size of 5 millimetres (0.2 in) to 50 mm (1.97 in). The sheet steel portion is customarily black oxide coated, but a variety of decorative painted color schemes are also available. The sheet steel portion is occasionally made of stainless steel, the more typical spring steel can also ...