Ad
related to: inline dimmer for lamp post base plate design spreadsheet
Search results
Results from the WOW.Com Content Network
Many memory consoles have a bank of faders. These faders can be programmed to control a single channel (a channel is a lighting designer's numerical name for a dimmer or group of dimmers) or a group of channels (known as a ""submaster""). The console may also have provision to operate in analog to a manual desk for programming scenes or live ...
A GU24 lamp fitting is a bi-pin connector for compact fluorescent lamps (CFL) or LED lamps that uses a bayonet mount–like twist-lock bi-pin connector instead of the Edison screw fitting used on many CFLs, LED lamps and incandescent light bulbs. The design was initiated by the U.S. EPA and the Lighting Research Center in 2004, in order to ...
A common dual dimmer module used in stage lighting A dimmer. A dimmer is a device connected to a light fixture and used to lower the brightness of the light.By changing the voltage waveform applied to the lamp, it is possible to lower the intensity of the light output.
Shown here will be fastened to this recessed, non-metallic box, then a cover plate is installed. This "double gang" (two unit) installation uses non-metallic-sheathed cable and twist-on wire connectors. In electrical wiring, a light switch is a switch most commonly used to operate electric lights, permanently connected equipment, or electrical ...
A dimmable ballast is very similar to a rapid start ballast, except that the autotransformer is connected to a dimmer. A quadrac type light dimmer can be used with a dimming ballast, which maintains the heating current while allowing lamp current to be controlled. A resistor of about 10 kΩ is required to be connected in parallel with the ...
Compared to a rheostat-based circuit, the use of a thyristor greatly increases efficiency, as far less waste heat is generated. Dimming lights with a solid state dimmer also reduces total power draw, unlike rheostat dimmers. Spira's design (and most modern dimmers) rely on the use of AC power, and on the characteristics of incandescent lights.
Remote Device Management (RDM) is an addition to the DMX512 control protocol for stage lighting equipment, introduced in 2006. DMX512 was developed in the late 1980s as a standard protocol for lighting consoles to communicate with dimmers, but has since been used for more complex applications, including the control of intelligent lighting fixtures.
A 3-way lamp, also known as a tri-light, is a lamp that uses a 3-way light bulb to produce three levels of light in a low-medium-high configuration. A 3-way lamp requires a 3-way bulb and socket, and a 3-way switch. In 3-way incandescent light bulbs, each of the filaments operates at full voltage. Lamp bulbs with dual carbon filaments were ...
Ad
related to: inline dimmer for lamp post base plate design spreadsheet