Search results
Results from the WOW.Com Content Network
Logo of Eurocode 2 An example of a concrete structure. In the Eurocode series of European standards (EN) related to construction, Eurocode 2: Design of concrete structures (abbreviated EN 1992 or, informally, EC 2) specifies technical rules for the design of concrete, reinforced concrete and prestressed concrete structures, using the limit state design philosophy.
The height of the ribs and beams should be 1 ⁄ 25 of the span between columns. [3] The width of the solid area around the column should be 1 ⁄ 8 of the span between columns. Its height should be the same as the ribs. [3] Diagram showing waffle slab rib and Beam Heights rule of thumb formulas.
IS: 4925 – specifications for concrete batching plant. IS: 3025 – tests on water samples; IS: 4990 – specifications for plywood formwork for concrete. IS: 9103 – specifications for concrete admixtures. IS: 12200 – specifications for PVC (Polyvinyl Chloride) water bars. IS: 1077 – specifications for bricks for masonry work.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
BS 5400-1:1988 Steel, concrete and composite bridges. General statement. BS 5400-2:2006 Steel, concrete and composite bridges. Specification for loads. BS 5400-3:2000 Steel, concrete and composite bridges. Code of practice for design of steel bridges. (This part of standard is being partially replaced) BS 5400-4:1990 Steel, concrete and ...
The design begins by determining the requirements of the concrete. These requirements take into consideration the weather conditions that the concrete will be exposed to in service, and the required design strength. The compressive strength of a concrete is determined by taking standard molded, standard-cured cylinder samples.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The flow table test or slump-flow test is a method to determine consistency of fresh concrete. Flow table test is also used to identify transportable moisture limit of solid bulk cargoes. [ 1 ] It is used primarily for assessing concrete that is too fluid (workable) to be measured using the slump test , because the concrete will not retain its ...