Search results
Results from the WOW.Com Content Network
Braced frame construction, also known as full frame, half frame, [6] New England braced frame, [7] combination frame [8] an early form of light framing which survived into the 1940s in the northeastern United States, [9] defined by the continued use of girts, corner posts, and braces, most often mortised, tenoned, and pegged with nailed studs. [8]
Vertical, metal furring is applied to the wall to create a channel and receive the siding material. In construction, furring (furring strips) are strips of wood or other material applied to a structure to level or raise the surface, to prevent dampness, to make space for insulation, to level and resurface ceilings or walls, [1] or to increase the beam of a wooden ship.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 inch (6 mm) thick. Each horizontal course of lath is spaced about 3 ⁄ 8 inch (9.5 mm) away from its neighboring courses.
The staff bead, a 1-inch dowel with approx 1 ⁄ 3 shaved off the back, is set on the external corner by the joiner on site, fastened to wooden plugs set into the brick/block seams, or to the wood frame. Plaster is run up to the staff bead and then cut back locally to the bead or "quirked" to avoid a weak feather edge where the plaster meets ...
Stucco plaster reliefs, such as this work at the Château de Fontainebleau, were hugely influential in Northern Mannerism. A plaster low-relief decorative frieze is above it. Plaster is a building material used for the protective or decorative coating of walls and ceilings and for moulding and casting decorative elements. [1]
Typically they range in size from 30 by 48 inches (76 cm × 122 cm) to 36 by 60 inches (91 cm × 152 cm). They are, as one would expect, considerably heavier than the gypsum core type panels. Portland cement based panels are ideal for truly wet locations like shower surrounds and for locations where a Portland cement based thin-set material is ...