Search results
Results from the WOW.Com Content Network
The axle load of a wheeled vehicle is the total weight bearing on the roadway for all wheels connected to a given axle.Axle load is an important design consideration in the engineering of roadways and railways, as both are designed to tolerate a maximum weight-per-axle (axle load); exceeding the maximum rated axle load will cause damage to the roadway or railway tracks.
The Federal Bridge Gross Weight Formula, also known as Bridge Formula B or the Federal Bridge Formula, is a mathematical formula in use in the United States by truck drivers and Department of Transportation (DOT) officials to determine the appropriate maximum gross weight for a commercial motor vehicle (CMV) based on axle number and spacing ...
The kingpins were now fixed to the axle ends and the hub carriers pivoted upon them. Most commonly the centre of the kingpin was fixed in the axle and the hub carrier was forked to fit over this, but some vehicles, including the Ford Model T illustrated, used a forked axle and a kingpin fixed into a single piece carrier.
These are the type most commonly used in automotive applications (to support the wheels of a motor car for example), where they are used in pairs to accommodate axial thrust in either direction, as well as radial loads. They can support greater thrust loads than the ball type due to the larger contact area, but are more expensive to manufacture.
The load can often be expressed as a curve of force versus speed. For instance, a given car traveling on a road of a given slope presents a load which the engine must act against. Because air resistance increases with speed, the motor must put out more torque at a higher speed in order to maintain the speed.
This coupling features two face-to-face magnetized disks: the driving magnet on the dry side, and the driven magnet on the underwater side. Torque is transferred by shear forces between the attracting magnetic disks, [5] but this attraction can also produce an axial load as the disks pull on each other. There are two main designs for the ...
The following stresses are induced in the shafts.. Shear stresses due to the transmission of torque (due to torsional load).; Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft.
Stiffness of the shaft and its support; Total mass of shaft and attached parts; Unbalance of the mass with respect to the axis of rotation; The amount of damping in the system; In general, it is necessary to calculate the critical speed of a rotating shaft, such as a fan shaft, in order to avoid issues with noise and vibration.