Search results
Results from the WOW.Com Content Network
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
Figure 1: The optical circuit symbol for an isolator Faraday effect. The main component of the optical isolator is the Faraday rotator. The magnetic field, , applied to the Faraday rotator causes a rotation in the polarization of the light due to the Faraday effect. The angle of rotation, , is given by,
A schematic pinout of an extremely simple opto-isolator device. Often diode and transistor protection and/or amplification will be added. The dashed line in the centre represents to isolation barrer, over which no electrical contact can be permitted.
Opto-isolator: often changed to "U" for IC P: Plug (most-movable connector of a connector pair), plug connector (connector may have "male" pin contacts and/or "female" socket contacts) PD: Photodiode: Q: Transistor (all types) R: Resistor: RN: Resistor network: sometimes simplified to "R" for resistor, or "N" for network RT: Thermistor
Galvanic isolation is used where two or more electric circuits must communicate, but their grounds may be at different potentials. It is an effective method of breaking ground loops by preventing unwanted current from flowing between two units sharing a ground conductor. Galvanic isolation is also used for safety, preventing accidental electric ...
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
This is not unusual – when an atom "lases" it always gives up its energy in the same direction and phase as the incoming light. Thus all of the additional signal power is guided in the same fiber mode as the incoming signal. An optical isolator is usually placed at the output to prevent reflections returning from the attached fiber. Such ...
Opto-isolator VTL2C1 with LED input and photoresistor output. Resistive opto-isolator (RO), also called photoresistive opto-isolator, vactrol (after a genericized trademark introduced by Vactec, Inc. in the 1960s), analog opto-isolator [notes 1] or lamp-coupled photocell, [1] is an optoelectronic device consisting of a source and detector of light, which are optically coupled and electrically ...