Search results
Results from the WOW.Com Content Network
The heeled bullet design has many advantages, mainly when coupled with the straight or slightly tapered walled cases it appeared in. For pistols, converting a cap and ball revolver to use cartridges was as simple as cutting off part of the rear of the cylinder, replacing it with a frame-mounted ring, and changing the hammer. It also made new ...
The .38 Long Colt's predecessor, the .38 Short Colt, used a heeled bullet of 130 grains (8.4 g) at a nominal 770 ft/s (230 m/s), producing 165 ft⋅lbf (224 J) muzzle energy. The cylindrical "shank" or "bearing surface" of the bullet, just in front of the cartridge case mouth, was .374 or .375 in (9.50 or 9.53 mm) in diameter, the same as the ...
The .38 Short Colt, also known as .38 SC, is a heeled bullet cartridge intended for metallic cartridge conversions of the cap and ball Colt 1851 Navy Revolver from the American Civil War era. [1] Later, this cartridge was fitted with a 0.358-inch (9.1 mm) diameter inside-lubricated bullet in the 125–135 grains (8.1–8.7 g) range. [2] [3]
The last brass case length was 1.050 to 1.100" long and was created exclusively for hand loaders so that both heel-base and hollow-base bullets could be used interchangeably (note that cartridges made from the longest brass cases and heel-base bullets are too long to fit most .41 Long Colt revolvers).
As standard for the era, it featured heeled bullet with the same diameter of bullet and case neck equal to .38 inch; later versions discarded the feature and downsized the bullet, but the designation did not change. After World War I, the British military sought to replace pre-war revolvers with easier-to-handle weapons.
Introduced by Colt's with the New Line revolver in 1873, the .32 Colt was inspired by the .320 Revolver, also called the ".32 Webley". [1] It originally used a .313 in (7.95 mm)-diameter 90 gr (5.8 g) outside-lubricated heeled bullet, which was later changed to inside lubrication.
The original .44 Colt loading used a heeled, outside lubricated bullet. The major diameter of the bullet was approximately the groove diameter (.451 in) of the converted ".44" cap and ball revolver. The smaller "heel" at the base of the bullet was sized to fit inside the brass case at approximately .430 in. [2]
The .44 Remington Centerfire / 11.4x27mmR (often referred to as .44 Remington C.F. or .44 Remington) was a centerfire revolver cartridge with a heeled, externally lubricated bullet produced by the Remington Arms Company from 1875 until 1895.