Search results
Results from the WOW.Com Content Network
Hydropneumatic suspension is a type of motor vehicle suspension system, invented by Paul Magès, produced by Citroën, and fitted to Citroën cars, as well as being used under licence by other car manufacturers. Similar systems are also widely used on modern tanks and other large military vehicles.
The controllers are pressure cylinders containing a movable separator member between a gas and a liquid, said moveable member causing the actuation of directional control valve or valves. The controllers are used in a circuit after a pump that is followed by a valved-side branch, and beyond a check valve, so that this device can only discharge ...
The usual recoil system in modern quick-firing guns is the hydro-pneumatic recoil system. In this system, the barrel is mounted on rails on which it can recoil to the rear, and the recoil is taken up by a cylinder which is similar in operation to an automotive gas-charged shock absorber , and is commonly visible as a cylinder mounted parallel ...
The water is pumped from the harbour into a header tank and then fed by gravity to the pumps. The working pressure is 750 psi (5.2 MPa, or 52 bar) which was used to power the cranes, bridges and locks of Bristol Harbour. [citation needed] The original operating mechanism of Tower Bridge, London, also used this type of accumulator.
The total volume of the tank is V t. Case 2 is a tank in use, with the air pressure at pressure P (gauge) and a water volume of V. Referring to the diagram on the right, a pressure tank is generally pressurized when empty with a "charging pressure" P c, which is usually about 2 psi below the turn-on pressure P lo (Case 1).
The tank may contain pressures in excess of 3,000 pounds per square inch (210 bar), which could cause a fatal barotrauma injury to a person breathing it directly. A demand controlled regulator provides a flow of breathing gas at the ambient pressure (which varies by depth in the water).
The College Football Playoff selection committee enters its final two weeks of deliberation with a host of consequential decisions thrust on the 13 members.
The early version tanks (retroactively designated Strv 103A) were soon upgraded to B-standard. Adjustments to the hydro-pneumatic suspension increased elevation range from −10 through +12 degrees, to −11 through +16 degrees. [18] Stridsvagn 103C An upgrade programme was started in 1986 to fit all vehicles with improved fire control systems.