Search results
Results from the WOW.Com Content Network
Class B vacuum tube amplifiers are usually operated with grid current (class B 2). The bias voltage source must have low resistance and be able to supply the grid current. [3] When tubes designed for class B are employed, the bias can be as little as zero. Class C amplifiers are biased negatively at a point well beyond plate current cutoff ...
Plate detector circuit with cathode bias. Cathode bias RC time constant three times period of lowest carrier frequency. C L is typically around 250 pF.. In electronics, a plate detector (anode bend detector, grid bias detector) is a vacuum tube circuit in which an amplifying tube having a control grid is operated in a non-linear region of its grid voltage versus plate current transfer ...
The transmitting tubes TT21 and TT22 have almost identical transfer characteristics to KT88 but a different pinout, and by virtue of their anode being connected to the top cap have a higher plate voltage rating (1.25 kilovolt) and a higher power output capability of 200 watts in class AB1 push–pull.
The metal tube technology utilized for the 6L6 had been developed by General Electric and introduced in April 1935, with RCA manufacturing the metal envelope tubes for GE at that time. [8] Some of the advantages of metal tube construction over glass envelope tubes were smaller size, ruggedness, electromagnetic shielding and smaller ...
The pentode EL84/6BQ5 - 9 pin Noval base tube, that although different enough from the 6V6 not to justify rating it as an equivalent, because of its popularity and ready availability, plus having a close-enough similarity to make it possible, if bias is altered, adapters have been developed commercially to allow an amplifier designed for 6V6 ...
The simplest klystron tube is the two-cavity klystron. In this tube there are two microwave cavity resonators, the "catcher" and the "buncher". When used as an amplifier, the weak microwave signal to be amplified is applied to the buncher cavity through a coaxial cable or waveguide, and the amplified signal is extracted from the catcher cavity.
The semiconductor or vacuum tube conducts throughout the entire RF cycle. The mean anode current for a vacuum tube should be set to the middle of the linear section of the curve of the anode current vs grid bias potential. Class-B amplifiers can be 60–65% efficient. The semiconductor or vacuum tube conducts through half the cycle but requires ...
A bias tee is a three-port network used for setting the DC bias point of some electronic components without disturbing other components. The bias tee is a diplexer.The low-frequency port is used to set the bias; the high-frequency port passes the radio-frequency signals but blocks the biasing levels; the combined port connects to the device, which sees both the bias and RF.