Search results
Results from the WOW.Com Content Network
In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...
An aerator attached to a sink tap. A faucet aerator (or tap aerator) is often found at the tip of modern indoor water faucets.Aerators can simply be screwed onto the faucet head, creating a non-splashing stream and often delivering a mixture of water and air.
This "air gap" is visible above the sink as a small cylindrical fixture mounted near the faucet. In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained ...
A bottom mount sink at the Ernest Hemingway House. Bottom-mount or under-mount sinks are installed below the countertop surface. The edge of the countertop material is exposed at the hole created for the sink (and so must be a carefully finished edge rather than a rough cut). The sink is then clamped to the bottom of the material from below.
The advantage to the pre-cast trench drain is again time savings—big time savings at the job site. Pre-cast trench drains made of a polymer concrete are also more sturdy and reliable than cast-in-place trenches. Once a trough is dug, the pre-cast trench sections can be installed and quickly be put into service through numerous methods.
Bags of flour on end cap. In addition to products displayed on the end of an aisle, promoted space on a retail shelf can be referred to as a fixture. Companies will oftentimes purchase a smaller amount of shelf space before making the move to an endcap at the end of an aisle. [citation needed]
This view looking upwards through a hole in the ceiling shows a traditional leaded hub joint (at top) and a more recent rubber-sleeved hubless connection (at lower right). Because they operate at low pressure and rely on gravity to move fluids (and entrained solids), drain-waste-vent systems use fittings whose interior surfaces are as smooth as ...
A chase nipple has male threads on one end only. The other end is a hexagon. The chase nipple passes through the knockouts of two boxes, and is secured by an internally threaded ring called a lock nut. [1] [2] Chase-Shawmut Company, of Boston, is the company which first produced chase nipples. [3]