Search results
Results from the WOW.Com Content Network
Or it may couple various parts together so that they move in unison – the primary example of this being a flexible drive to mate two shafts in order to transmit torque. Some devices use dog clutches to lock together two spinning components. In a manual transmission, the dog clutches, or "dogs" lock the selected gear to the shaft it rotates on ...
A dog may misuse its rear legs, or adapt its gait, to compensate for pain in the forelimbs, notably osteoarthritis, osteochondritis (OCD) or shoulder or elbow dysplasia, as well as pain in the hocks and stifles or spinal issues. It is important to rule out other joint and bodily issues before concluding that only hip dysplasia is present.
When the dog pulls, a strap within the harness tightens. [11] applying pressure on the dog's body which the dog must actively alter the pulling behavior to avoid. [12] If the dog pulls, the leash goes off to the side and directs the dog back towards the owner. That gives a greater ability to control and guide the dog by applying a little ...
A dog with degenerative myelopathy often stands with its legs close together and may not correct an unusual foot position due to a lack of conscious proprioception. Canine degenerative myelopathy, also known as chronic degenerative radiculomyelopathy, is an incurable, progressive disease of the canine spinal cord that is similar in many ways to amyotrophic lateral sclerosis (ALS).
A lathe dog is a mechanical device typically made of cast iron, steel or aluminum that transmits rotary motion from a faceplate to a workpiece mounted between centers in a lathe. [1] The tail of the dog is rotated by a slot in a driving faceplate, a stud mounted on a faceplate, or sometimes a side of a chuck jaw.
Dog with partially docked tail. Docking or bobbing is the removal of portions of an animal's tail.It should not be confused with cropping, [1] the amputation of ears. Tail docking may be performed cutting the tail with surgical scissors (or a scalpel) or constricting the blood supply to the tail with a rubber ligature for a few days until the tail falls off. [2]
A dog uses its back to attain speed. The back's most flexible point is just over the loin area, and the tuck-up allows for the folding of the under portion of the dog's body. The rear legs overreach on the outside of the front legs. Essential for a fast dog is the ability to flex its back from a straight position to an arched position.
The injury affects the tail of the dog, causing it to be painful at or near its base. Limber tail can be recognized by a very flaccid tail, or a tail that is held horizontally for approximately 10 cm, and then drops vertically. The condition is also more pronounced in dogs that wag their tails a lot. Some dogs may also pant or shake.