Search results
Results from the WOW.Com Content Network
Shay Motors Corporation was an automobile company founded by Harry J. Shay in February 1978 as the Model A & Model T Motor Car Reproduction Corporation. [1] Harry Shay arranged with Ford Motor Company to build a limited run, modern-day reproduction of the Ford Model A Roadster, with a rumble seat, that was to be sold through the network of Ford Automobile Dealers and built in Battle Creek ...
The Ford Model T is an automobile that was produced by the Ford Motor Company from October 1, 1908, to May 26, 1927. [16] It is generally regarded as the first mass-affordable automobile, which made car travel available to middle-class Americans. [17]
The rear axle of the TT has a worm drive [1] and crown wheel, unlike the Model T's crown wheel and pinion. The worm is located at the end of the drive shaft and above the crown wheel. The wheelbase of the Model TT is 125 inches (3,175 mm), compared to 100 inches (2,540 mm) for the Model T.
Cutaway view of the fuel system for the Ford Model T engine, showing the gravity-feed fuel supply, carburetor cutaway, and intake stream. [4] The Ford Model T engine had one carburetor, a side-draft, single-venturi unit. Its choke and throttle valves were controlled manually; the latter was with a hand lever rather than a foot pedal. The ...
Roadster bodies were offered on automobiles of all sizes and classes, from mass-produced cars like the Ford Model T and the Austin 7 to extremely expensive cars like the Cadillac V-16, the Duesenberg Model J and Bugatti Royale. 1920s to 1950s roadsters
Bradley offered the backlite in three variations; a short three-sided piece, a longer fastback piece that extended back to the base of the rear spoiler, or an extended wagon-back rear cover. The power output or even type of engine could also vary widely, depending on the owner/builder's wishes. The Bradley GT was in production from 1970 to 1981 ...
[7] [6] The first hot rods were old cars (most often Fords, typically 1910s-1920s Model Ts, 1928–31 Model As, or 1932-34 Model Bs), modified to reduce weight. Engine swaps often involved fitting the Ford flathead V8 engine (known as the "flatty") into a different car, for example, the common practice [ citation needed ] in the 1940s of ...
The car went on sale in March 2009, with delivery beginning in summer. [45] In 2010, the TT-RS was confirmed for the US market. The decision was influenced by an internet petition to bring the TT-RS stateside, which succeeded with over 11,000 signatures. [46] The TT-RS arrived in Q3 2011 as a 2012 model. In 2012, the TT RS plus was launched.