Search results
Results from the WOW.Com Content Network
The 96-pin Euro-DIN connector is similar to the SE slot connector, but the two are completely incompatible. Latter models added 18 more pins through a notched in-line extension to support the full MC68030 bus (synchronous cycle, all address lines, clock both from the CPU and backward-compatible 16 MHz), while retaining backwards compatibility ...
Open collector, open drain, open emitter, and open source refer to integrated circuit (IC) output pin configurations that process the IC's internal function through a transistor with an exposed terminal that is internally unconnected (i.e. "open").
Such a configuration is called a "half bridge". [4] It acts as an electronic toggle switch, the half bridge is not able to switch polarity of the voltage applied to the load. The half bridge is used in some switched-mode power supplies that use synchronous rectifiers and in switching amplifiers. The half-H bridge type is commonly abbreviated to ...
SMEMA is an acronym for the Surface Mount Equipment Manufacturers Association.. In 1999 they merged with the IPC to form the IPC SMEMA Council. [1]One standard they have is for the wiring of communications between Surface mount technology producing machinery such as a Stencil Printer or a Pick and Place Machine on an Electronics production line.
In the analysis of a bipolar junction transistor, for example, in a common-emitter configuration, the DC voltage at the collector, emitter, and base (with respect to ground) may be written as V C, V E, and V B respectively. Resistors associated with these transistor terminals may be designated R C, R E, and R B.
When a jumper is on or covering at least two pins it is a closed jumper, when a jumper is off, is covering only one pin, or the pins have no jumper it is an open jumper. Jumperless designs have the advantage that they are usually fast and easy to set up, often require little technical knowledge, and can be adjusted without having physical ...
The Type 2 connector is equipped with seven pin connectors, which are used for communication between the vehicle and charger using the J1772 signaling protocol, and for either single or 3-phase AC power with a maximum voltage of 500 V, thereby delivering up to 43kW of power. [1].
The UEXT connector consists of 10 pins, in a two row by five male pin configuration, with a plastic keyed-shrouded or box header (specifically BH10S). All pins have a spacing of 0.1 inch (2.54 mm). [1] [2] The socket is mated with a 2×5 (10-pin) IDC female connector, and typically connected to a ribbon cable.