Ad
related to: boiling tube in laboratory work
Search results
Results from the WOW.Com Content Network
A boiling tube is a large test tube intended specifically for boiling liquids. A test tube filled with water and upturned into a water-filled beaker is often used to capture gases, e.g. in electrolysis demonstrations. A test tube with a stopper is often used for temporary storage of chemical or biological samples.
The Thiele tube, named after the German chemist Johannes Thiele, is a laboratory glassware designed to contain and heat an oil bath. Such a setup is commonly used in the determination of the melting point or boiling point of a substance. The apparatus resembles a glass test tube with an attached handle.
These tubes are usually made of glass, but can also be made of plastic or metal. They vary in size and purpose. Laboratory sample tubes must not be confused with glass tubing, which can be utilized to carry fluid between laboratory equipment. Example laboratory sample tubes are listed below: Ignition tube; Test tube; Boiling tube; NMR tube
While the outward designs of apparatuses can vary greatly, most apparatuses use a sample loaded into a sealed capillary tube (melting-point tube), which is then placed in the apparatus. The sample is then heated, either by a heating block or an oil bath, and as the temperature increases, the sample is observed to determine when the phase change ...
A Thiele tube is an alternative heating vessel. The Siwoloboff method is used to determine the boiling point of small samples of liquid chemicals. A sample in an ignition tube (also called a fusion tube) is attached to a thermometer with a rubber band, and immersed in a Thiele tube, water bath, or other suitable medium for heating. A sealed ...
Round-bottom flasks are often used to contain chemical reactions run by chemists, especially for reflux set-ups and laboratory-scale synthesis. [3] Boiling chips are added in distilling flasks for distillations or boiling chemical reactions to allow a nucleation site for gradual boiling. This nucleation avoids a sudden boiling surge where the ...
Because the liquid is typically above its boiling point, when the liquid finally starts to boil, a large vapor bubble is formed that pushes the liquid out of the test tube, typically at high speed. This rapid expulsion of boiling liquid poses a serious hazard to others and oneself in the lab. Furthermore, if a liquid is boiled and cooled back ...
The two outer tubes (#3 and #4) form an insulating dead air chamber (shaded). Vapor rises from a boiling flask into space (1), proceeds up through the space between tubes #2 and #3, then down the space between tubes #1 and #2, and finally up between tube #1 and the central rod.
Ad
related to: boiling tube in laboratory work