Search results
Results from the WOW.Com Content Network
Isogrid on the interior of the adapter connecting the Orion spacecraft to the Delta IV rocket for Exploration Flight Test 1. Isogrid is a type of partially hollowed-out structure formed usually from a single metal plate with integral triangular stiffening stringers.
This aircraft first flew on June 19, 1964. Although several firms expressed interest in production of the design, all failed to provide the necessary downpayment. [2] The CCW-5 accommodated five persons, and its power plants are suspended in the center of the 6-foot (1.8 m)-chord wing channels on tubular frameworks attached to the wing spars.
Channel Wing aircraft CCW-5. The channel wing is an aircraft wing principle developed by Willard Ray Custer in the 1920s. The most important part of the wing consists of a half-tube with an engine placed in the middle, driving a propeller placed at the rear end of the channel formed by the half-tube.
In 2021 the first T-pylon, a new tubular T-shaped design, was installed in United Kingdom for a new power line to Hinkley Point C nuclear power station, carrying two high voltage 400 kV power lines. [ 10 ] [ 11 ] The design features electricity cables strung below a cross-arm atop a single pole which reduces the visual impact on the environment ...
The Tubular Exchanger Manufacturers Association (also known as TEMA) is an association of fabricators of shell and tube type heat exchangers. [1] TEMA has established and maintains a set of construction standards for heat exchangers, known as the TEMA Standard. [ 2 ]
Anchor channels and channel bolts are qualified in Europe according to EAD 330008-XX-0601 and designed according to EN 1992-4. In the US, the system is qualified according to Acceptance Criteria AC232 and designed according to AC232 and ACI 318.
A powered de Dion suspension uses universal joints on both ends of its driveshafts (at the wheel hubs and at the differential), and a solid tubular beam to hold the opposite wheels in parallel. Unlike an anti-roll bar , a de Dion tube is not directly connected to the chassis , and is not intended to flex.
The structural channel is not used as much in construction as symmetrical beams, in part because its bending axis is not centered on the width of the flanges. If a load is applied equally across its top, the beam will tend to twist away from the web. This may not be a weak point or problem for a particular design, but is a factor to be ...