Search results
Results from the WOW.Com Content Network
For example, DB-25 denotes a D-sub with a 25-position shell size and a 25-position contact configuration. The contacts in each row of these connectors are spaced 326/3000 of an inch apart, or approximately 0.1087 inches (2.76 mm), and the rows are spaced 0.112 inches (2.84 mm) apart; the pins in the two rows are offset by half the distance ...
A diagram of the DB-25 connector. Date: 18 June 2006 (original upload date) ... Dimensions User Comment; current: 07:08, 23 June 2006: 558 × 150 (8 KB) Mobius ...
Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) "IDC header" which has two rows of pins, 0.1 inches apart. This connector has no retaining screws to secure the connectors together, and ribbon cables are both inconveniently wide and somewhat delicate, so this connector style was ...
Mini-Centronics 36-pin male connector (top) with Micro ribbon 36-pin male Centronics connector (bottom) The Apple II Parallel Printer Port connected to the printer via a folded ribbon cable; one end connected to the connector at the top of the card, and the other end had a 36-pin Centronics connector.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.