enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Corbel - Wikipedia

    en.wikipedia.org/wiki/Corbel

    In architecture, a corbel is a structural piece of stone, wood or metal jutting from a wall to carry a superincumbent weight, [1] a type of bracket. [2] A corbel is a solid piece of material in the wall, whereas a console is a piece applied to the structure. A piece of timber projecting in the same way was called a "tassel" or a "bragger" in ...

  3. Viga (architecture) - Wikipedia

    en.wikipedia.org/wiki/Viga_(architecture)

    Decorative corbels were used in the portales and in the interiors. New technologies, especially in Pueblo Revival Architecture, were integrated. The practice of anchoring vigas with rebar through pre-drilled holes at opposing angles and the designing of parapets for anchoring, was ideal for vigas in low flat roofs.

  4. Post (structural) - Wikipedia

    en.wikipedia.org/wiki/Post_(structural)

    Angle – A historical name for a corner post. Intermediate – A post in an exterior wall not at a corner. Chimney – An intermediate post receiving its name from being near a chimney. Interior – A general term for posts not in an exterior wall. Arcade – A post located between an aisle and nave. [10] Aisle – same as arcade post. [11]

  5. Glossary of architecture - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_architecture

    The capping or covering of a wall. Corbel A structural piece of stone, wood or metal jutting from a wall to carry a superincumbent weight. A corbie gable from Zaltbommel Corbiesteps A series of steps along the slopes of a gable. [17] Also called crow-steps. A gable featuring corbiesteps is known as a corbie gable, crow-step gable, or stepped ...

  6. Timber framing - Wikipedia

    en.wikipedia.org/wiki/Timber_framing

    sill-beams (also called ground-sills or sole-pieces, at the bottom of a wall into which posts and studs are fitted using tenons), noggin-pieces (the horizontal timbers forming the tops and bottoms of the frames of infill panels), wall-plates (at the top of timber-framed walls that support the trusses and joists of the roof).

  7. Hammerbeam roof - Wikipedia

    en.wikipedia.org/wiki/Hammerbeam_roof

    A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.

  8. Post and lintel - Wikipedia

    en.wikipedia.org/wiki/Post_and_lintel

    Post-and-lintel construction is one of four ancient structural methods of building, the others being the corbel, arch-and-vault, and truss. [ 1 ] A noteworthy example of a trabeated system is in Volubilis , from the Roman era, where one side of the Decumanus Maximus is lined with trabeated elements, while the opposite side of the roadway is ...

  9. Poteaux-sur-sol - Wikipedia

    en.wikipedia.org/wiki/Poteaux-sur-sol

    Poteaux-sur-sol ("posts on a sill" – sol is also spelled sole and solle) is a style of timber framing in which relatively closely spaced posts rest on a timber sill. Poteaux-en-terre and pieux-en-terre are similar, but the closely spaced posts extend into the ground rather than resting on a sill on a foundation, and therefore are a type of ...