Search results
Results from the WOW.Com Content Network
Mechanically seamed metal with concealed fasteners contains sealant in seams for use on very low sloped roofs, suitable for roofs of low pitch such as 0.5/12 to 3/12 pitch. Flat-seam metal with or without soldered seams. Steel coated with a coloured alloy of zinc and aluminium. Stone-coated metal roofing.
The best roof material for a home in Florida will vary depending on your budget and where your home is. If you’re right on the coast, then a metal roof or clay tile roof will be your best options.
Flat roofs, or "low-slope" roofs, are also commonly found on commercial buildings throughout the world. The U.S.-based National Roofing Contractors Association defines a low-slope roof as having a slope of 3 in 12 (1:4) or less. [2] Flat roofs exist all over the world, and each area has its own tradition or preference for materials used.
Ponding water accelerates the deterioration of many materials, including seam adhesives in single-ply roof systems, steel equipment supports, and particularly roofing asphalt. On low-slope asphalt roofs, ponding water allows the oil solvent components of the asphalt to leach out and evaporate, leaving the roof membrane brittle and susceptible ...
Asphalt roll roofing or membrane is a roofing material commonly used for buildings that feature a low sloped roof pitch in North America. The material is based on the same materials used in asphalt shingles ; an organic felt or fiberglass mat, saturated with asphalt , and faced with granular stone aggregate.
Bell-cast (sprocketed, flared): A roof with the shallow slope below the steeper slope at the eaves. Compare with bell roof. East Asian hip-and-gable roof; Mokoshi: A Japanese decorative pent roof; Pavilion roof : A low-pitched roof hipped equally on all sides and centered over a square or regular polygonal floor plan. [10]
A flat roof includes pitches as low as 1 ⁄ 2:12 to 2:12 (1 in 24 to 1 in 6), which are barely capable of properly shedding water. Such low-slope roofs (up to 4:12 (1 in 3)) require special materials and techniques to avoid leaks. [4] Conventional describes pitches from 4:12 (1 in 3) to 9:12 (3 in 4). [4]
The pitch of a cricket is sometimes the same as the rest of the roof, but not always. For Steep-slope roofs, it is most common to have the cricket pitch to be equal to or less than the main roof, however for low-slope or flat roofs, it is more common to see the cricket be at least 50% greater slope than the roof, to minimize ponding.