Search results
Results from the WOW.Com Content Network
Ray-traced image of a piston engine. There may be one or more pistons. Each piston is inside a cylinder, into which a gas is introduced, either already under pressure (e.g. steam engine), or heated inside the cylinder either by ignition of a fuel air mixture (internal combustion engine) or by contact with a hot heat exchanger in the cylinder (Stirling engine).
1919 Napier Lion II aircraft engine with three cylinder banks. Any design of motor/engine,be it a V or a boxer can be called an "in-line" if it's mounted in-line with the frame/chassis and in-line with the direction of travel of the vehicle.When the motor/engine is across the frame/chassis this is called a TRANSVERSE motor.Cylinder arrangement is not in the description of how the motor/engine ...
The higher cost of turbines and the associated gears or generator/motor sets is offset by lower maintenance requirements and the smaller size of a turbine in comparison with a reciprocating engine of equal power, although the fuel costs are higher than those of a diesel engine because steam turbines have lower thermal efficiency. To reduce fuel ...
A turbo-compound engine is a reciprocating engine that employs a turbine to recover energy from the exhaust gases. Instead of using that energy to drive a turbocharger as found in many high-power aircraft engines , the energy is instead sent to the output shaft to increase the total power delivered by the engine.
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
Steam powers two types of engine, reciprocating (with steam driving pistons connected to a crankshaft) and turbine (with steam driving blades attached radially to a spinning shaft). The shaft power from each can either go directly to the propeller, pump jet or other mechanism, or it goes through some form of transmission; mechanical, electrical ...
Steam engines and turbines operate on the Rankine cycle which has a maximum Carnot efficiency of 63% for practical engines, with steam turbine power plants able to achieve efficiency in the mid 40% range. The efficiency of steam engines is primarily related to the steam temperature and pressure and the number of stages or expansions. [15]
A steam turbine from MAN SE subsidiary MAN Turbo. In general, the two kinds of turbomachines encountered in practice are open and closed turbomachines. Open machines such as propellers, windmills, and unshrouded fans act on an infinite extent of fluid, whereas closed machines operate on a finite quantity of fluid as it passes through a housing or casing.