Search results
Results from the WOW.Com Content Network
This scale was used by Revell for some ship models because it was one-half the size of the standard scale for wargaming models used by the U.S. Army. 1:535: 0.022: 0.570 mm: Ship models: Scale used by Revell for USS Missouri ship. Sometimes called "box scale" because chosen to fit a box size. 1:500: 0.610 mm: Architecture. Ship models. Die-cast ...
Aside from the Orthographic, six standard principal views (Front; Right Side; Left Side; Top; Bottom; Rear), descriptive geometry strives to yield four basic solution views: the true length of a line (i.e., full size, not foreshortened), the point view (end view) of a line, the true shape of a plane (i.e., full size to scale, or not ...
Various scales may be used for different drawings in a set. For example, a floor plan may be drawn at 1:50 (1:48 or 1 ⁄ 4 ″ = 1′ 0″) whereas a detailed view may be drawn at 1:25 (1:24 or 1 ⁄ 2 ″ = 1′ 0″). Site plans are often drawn at 1:200 or 1:100. Scale is a nuanced subject in the use of engineering drawings.
For example, 1:48 scale is 1/4" to 1-foot (or 1" to 4 feet) and 1:72 is 1" to 6 feet, while in metric scales such as 1:100th, 1 centimeter equals 1 meter. 1:72 scale was introduced with Skybirds wood and metal model aircraft kits in 1932 and were followed closely by Frog, which used the same scale from 1936 with their "Frog Penguin" brand. 1:72 ...
The sectionals are complemented by terminal area charts (TACs) at 1:250,000 scale for the areas around major U.S. airports, and until 2016 by World Aeronautical Charts (WACs) at a scale of 1:1,000,000 for pilots of slower aircraft and aircraft at high altitude. [1] Since February 2021, the charts have been updated on a 56-day publication cycle. [2]
A scale factor of 1 is normally allowed, so that congruent shapes are also classed as similar. Uniform scaling happens, for example, when enlarging or reducing a photograph, or when creating a scale model of a building, car, airplane, etc. More general is scaling with a separate scale factor for each axis direction.
Plans are usually "scale drawings", meaning that the plans are drawn at a specific ratio relative to the actual size of the place or object. Various scales may be used for different drawings in a set. For example, a floor plan may be drawn at 1:48 (or 1/4"=1'-0") whereas a detailed view may be drawn at 1:24 (or 1/2"=1'-0").
Models are built to scale, defined as the ratio of any linear dimension of the model to the equivalent dimension on the full-size subject (called the "prototype"), expressed either as a ratio with a colon (ex. 1:8 scale), or as a fraction with a slash (1/8 scale). This designates that 1 inch (or centimeter) on the model represents 8 such units ...