enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Splint (laboratory equipment) - Wikipedia

    en.wikipedia.org/wiki/Splint_(laboratory_equipment)

    In this test, a splint is lit, allowed to burn for a few seconds, then blown out by mouth or by shaking. Whilst the ember at the tip is still glowing hot, the splint is introduced to the gas sample that has been trapped in a vessel. [4] Upon exposure to concentrated oxygen gas, the glowing ember flares, and re-ignites to produce a sustained flame.

  3. Elephant's toothpaste - Wikipedia

    en.wikipedia.org/wiki/Elephant's_toothpaste

    [specify] [2] [3] A glowing splint can be used to show that the gas produced is oxygen. [9] The rate of foam formation measured in volume per time unit has a positive correlation with the peroxide concentration (v/V%), which means that more foam will be generated per unit time when a more concentrated peroxide solution is used. [10]

  4. Flame test - Wikipedia

    en.wikipedia.org/wiki/Flame_test

    A flame test is relatively quick test for the presence of some elements in a sample. The technique is archaic and of questionable reliability, but once was a component of qualitative inorganic analysis .

  5. Orsat gas analyser - Wikipedia

    en.wikipedia.org/wiki/Orsat_gas_analyser

    Copper(I) chloride (ammoniacal Cuprous chloride) for carbon monoxide Any left-over gas is assumed to be nitrogen, though other absorbents or vessels can be used to isolate additional gases. Platinum on asbestos for example can be used to determine the hydrogen content of a sample, and the Fischer-type Orsat gas analyser for example uses a ...

  6. Chemical test - Wikipedia

    en.wikipedia.org/wiki/Chemical_test

    The Schiff test detects aldehydes; Tollens' reagent tests for aldehydes (known as the silver mirror test) The Zeisel determination tests for the presence of esters or ethers; Lucas' reagent is used to distinguish between primary, secondary and tertiary alcohols. The bromine test is used to test for the presence of unsaturation and phenols.

  7. Benzotrichloride - Wikipedia

    en.wikipedia.org/wiki/Benzotrichloride

    The concentration in the blood peaked at 4 h reaching 6.5 ppm, this decreased to 2.6 ppm after 24 h. The elimination of half-life in blood was 22 h. Elimination took place for 90% through urine and 10% through faeces. After 72 hours 1.5% of the dose was still present in tissue. The highest concentration levels were present in liver, kidney and ...

  8. Electrochlorination - Wikipedia

    en.wikipedia.org/wiki/Electrochlorination

    That is, energy is added to sodium chloride (table salt) in water, producing sodium hypochlorite and hydrogen gas. Because the reaction takes place in an unpartitioned cell and NaOH is present in the same solution as the Cl 2: 2 NaCl + 2 H 2 O → 2 NaOH + H 2 + Cl 2. any Cl 2 disproportionates to hypochlorite and chloride Cl 2 + 2 NaOH → ...

  9. Acute Exposure Guideline Levels - Wikipedia

    en.wikipedia.org/.../Acute_Exposure_Guideline_Levels

    Each AEGL is determined by different levels of a compound's toxicological effects, based on the 4 Ds: detection, discomfort, disability and death. There are three levels of AEGL-values: AEGL-1, AEGL-2 and AEGL-3. [2] AEGL-1 is the airborne concentration above which notable discomfort or irritation could be experienced. However, the effects are ...