Ads
related to: comp cams roller lifters installation kit
Search results
Results from the WOW.Com Content Network
Its solid-lifter cam, known as the "30-30 Duntov" cam named after its 0.03 in (0.8 mm)/0.030 in hot intake/exhaust valve-lash and Zora Arkus-Duntov (the first Duntov cam was the 0.012 in (0.3 mm)/0.018 in (0.5 mm) 1957 grind known as the '097, which referred to the last three digits of the casting number) the "Father of the Corvette", was also ...
A similar arrangement transfers the motion via another roller tip to a second rocker arm. This rotates about the rocker shaft, and transfers the motion via a tappet to the valve. [clarify] Some OHC engines employ short rocker arms, also known as fingers, in which the cam lobe pushes down (rather than up) on the rocker arm to open the valve.
the camshaft is secured to the cylinder head with the camcase. An oil passage in the cylinder head provides the passageway in the camcase with oil that leads to the intake rocker shaft. Oil from the camshaft is collected on the opposite side of the passageway leading to the intake rocker shaft to provide oil to the exhaust rocker shaft.
The block was fitted with revised, taller lifter bosses to accept roller lifters, and a steel camshaft in 1985, and electronic sequential fuel injection was introduced in 1986. While sequential injection was used on the Mustang beginning in 1986, many other vehicles, including trucks, continued to use a batch-fire fuel injection system.
The Northstar engine is a family of high-performance 90° V engines produced by General Motors between 1993 and 2011. Regarded as GM's most technically complex engine, the original double overhead cam, four valve per cylinder, aluminum block/aluminum head V8 design was developed by Oldsmobile R&D, [citation needed] but is most associated with Cadillac's Northstar series.
Unlike the 3800, however, it used a batch-fire injection system rather than sequential injection, as evidenced by the lack of a cam position sensor. It also did not have a balance shaft. Power output was 160 hp (119 kW) at 5,200 rpm and 185 lb⋅ft (251 N⋅m) at 2,000 rpm with a 5,500 rpm redline.
The valves are actuated by Cobra-specific 1.7 ratio roller rockers, constructed of aluminum, and produced for Ford by Crane Cams. Intake Manifold — The Cobra upper manifold was unique to the 1993 Cobra and had a 2.75 in (69.85 mm) diameter round throttle body opening, diverting air into (8) round staggered ports, each 1.64 in (41.66 mm) in ...
The camshaft timing was also changed. The net result was an engine that made 190 hp (142 kW; 193 PS) and 225 lb⋅ft (305 N⋅m). Badging on most Jeeps equipped with this engine reads "4.0 Litre HIGH OUTPUT." The new cam profile combined with altered computer programming eliminated the need for an EGR valve and knock sensor, but made the engine ...
Ads
related to: comp cams roller lifters installation kit