Search results
Results from the WOW.Com Content Network
Logarithms can be used to make calculations easier. For example, two numbers can be multiplied just by using a logarithm table and adding. These are often known as logarithmic properties, which are documented in the table below. [2] The first three operations below assume that x = b c and/or y = b d, so that log b (x) = c and log b (y) = d.
For example, the pH of a 0.01 in moles per litreM solution of hydrochloric acid (HCl) is equal to 2 (pH = −log 10 (0.01)), while the pOH of a 0.01 M solution of sodium hydroxide (NaOH) is equal to 2 (pOH = −log 10 (0.01)), which corresponds to a pH of about 12.
An LNS can be considered as a floating-point number with the significand being always equal to 1 and a non-integer exponent. This formulation simplifies the operations of multiplication, division, powers and roots, since they are reduced down to addition, subtraction, multiplication, and division, respectively.
In mathematics, the logarithm of a number is the exponent by which another fixed value, the base, must be raised to produce that number.For example, the logarithm of 1000 to base 10 is 3, because 1000 is 10 to the 3 rd power: 1000 = 10 3 = 10 × 10 × 10.
The distribution coefficient, log D, is the ratio of the sum of the concentrations of all forms of the compound (ionized plus un-ionized) in each of the two phases, one essentially always aqueous; as such, it depends on the pH of the aqueous phase, and log D = log P for non-ionizable compounds at any pH.
Example Bjerrum plot: Change in carbonate system of seawater from ocean acidification.. A Bjerrum plot (named after Niels Bjerrum), sometimes also known as a Sillén diagram (after Lars Gunnar Sillén), or a Hägg diagram (after Gunnar Hägg) [1] is a graph of the concentrations of the different species of a polyprotic acid in a solution, as a function of pH, [2] when the solution is at ...
The point of zero charge (pzc) is generally described as the pH at which the net electrical charge of the particle surface (i.e. adsorbent's surface) is equal to zero. This concept has been introduced in the studies dealing with colloidal flocculation to explain why pH is affecting the phenomenon. [1]
If the power quantity P is proportional to F 2, and if the reference value of the power quantity, P 0, is in the same proportion to F 0 2, the levels L F and L P are equal. The neper , bel , and decibel (one tenth of a bel) are units of level that are often applied to such quantities as power, intensity, or gain. [ 6 ]