Search results
Results from the WOW.Com Content Network
SCPI was defined as an additional layer on top of the IEEE 488.2-1987 specification "Standard Codes, Formats, Protocols, and Common Commands". [4] The standard specifies a common syntax, command structure, and data formats, to be used with all instruments.
A general-purpose input/output (GPIO) is an uncommitted digital signal pin on an integrated circuit or electronic circuit (e.g. MCUs/MPUs) board which may be used as an input or output, or both, and is controllable by software. GPIOs have no predefined purpose and are unused by default.
IEEE 488 cable with stacking connectors. IEEE 488, also known as HP-IB (Hewlett-Packard Interface Bus) and generically as GPIB (General Purpose Interface Bus), is a short-range digital communications 8-bit parallel multi-master interface bus specification developed by Hewlett-Packard.
It is sometimes called a four-wire serial bus to contrast with three-wire variants which are half duplex, and with the two-wire I²C and 1-Wire serial buses. Typical applications include interfacing microcontrollers with peripheral chips for Secure Digital cards, liquid crystal displays , analog-to-digital and digital-to-analog converters ...
The word "uno" means "one" in Italian and was chosen to mark a major redesign of the Arduino hardware and software. [7] The Uno board was the successor of the Duemilanove release and was the 9th version in a series of USB-based Arduino boards. [8] Version 1.0 of the Arduino IDE for the Arduino Uno board has now evolved to newer releases. [4]
English: Contents of Serial Programming that has been turned into a PDF file as a "published" book. Version as of date of PDF file. Version as of date of PDF file. This file was created with MediaWiki to LaTeX .
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
JTAG (named after the Joint Test Action Group which codified it) is an industry standard for verifying designs of and testing printed circuit boards after manufacture.. JTAG implements standards for on-chip instrumentation in electronic design automation (EDA) as a complementary tool to digital simulation. [1]