Search results
Results from the WOW.Com Content Network
Bend radius, which is measured to the inside curvature, is the minimum radius one can bend a pipe, tube, sheet, cable or hose without kinking it, damaging it, or shortening its life. The smaller the bend radius, the greater the material flexibility (as the radius of curvature decreases , the curvature increases ).
A pipe support or pipe hanger is a designed element that transfer the load from a pipe to the supporting structures. The load includes the weight of the pipe proper, the content that the pipe carries, all the pipe fittings attached to pipe, and the pipe covering such as insulation. The four main functions of a pipe support are to anchor, guide ...
Visualise bending the left end of the pipe up 88 degrees. Now turn the piece of pipe around so the horizontal piece of pipe is in line with the zero degrees line on the protractor. The protractor will read 92 degrees. The key point is that the plumbing term focuses on the degree of bend from the original straight pipe, not the resulting angle.
These standard pipe threads are formally referred to by the following sequence of blocks: the words, Pipe thread, the document number of the standard (e.g., ISO 7 or EN 10226) the symbol for the pipe thread type: G, external and internal parallel (ISO 228) R, external taper (ISO 7) Rp, internal parallel (ISO 7/1) Rc, internal taper (ISO 7)
The load applied to the reduced-thickness spring to obtain a deflection equal to the 75% of the free height (of an unreduced spring) must be the same as for an unreduced spring. As the overall height is not reduced, springs with reduced thickness inevitably have an increased flank angle and a greater cone height than springs of the same nominal ...
These are strong but flexible springs inserted into a pipe to support the pipe walls during manual bending. They have diameters only slightly less than the internal diameter of the pipe to be bent. They are only suitable for bending 15-and-22 mm (0.6-and-0.9 in) soft copper pipe (typically used in household plumbing) or PVC pipe.
The SCR pipe and a short segment of pipe lying on the seabed use 'dynamic' pipe, i.e. steel pipe having slightly greater wall thickness than the pipeline wall thickness, in order to sustain dynamic bending and steel material fatigue associated in the touch-down zone of the SCR. Beyond that the SCR is typically extended with a rigid pipeline ...
A flat spring fixed only at one end like a cantilever, while the free-hanging end takes the load. Coil spring Also known as a helical spring. A spring (made by winding a wire around a cylinder) is of two types: Tension or extension springs are designed to become longer under load. Their turns (loops) are normally touching in the unloaded ...