Search results
Results from the WOW.Com Content Network
powerbutton put the machine to sleep when the power button pressed instead of shutting it down, 1 to enable or 0 to disable; powernap lets machine stay up to date even while they're sleeping, 1 to enable or 0 to disable; lidwake (laptop only) wake the machine when the laptop lid is opened, 1 to enable or 0 to disable
Active-state power management (ASPM) is a power management mechanism for PCI Express devices to garner power savings while otherwise in a fully active state. Predominantly, this is achieved through active-state link power management; i.e., the PCI Express serial link is powered down when there is no traffic across it.
DevSlp or DevSleep (sometimes referred to as device sleep or SATA DEVSLP) is a feature in some SATA devices which allows them to go into a low power "device sleep" mode when sent the appropriate signal, which uses one or two orders of magnitude less power than a traditional idle (about 5 mW, [1] but some drives can get as low as 2.5 mW [2]).
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
The method by which a sleep proxy server wakes a sleeping host is wake-on-LAN. The network interface of a sleeping host with this capability will wake the machine when it receives a specific series of bits, and a packet containing this pattern is a magic packet. Early implementations of Wake on LAN (WoL) required
A real time clock alarm is a feature that can be used to allow a computer to 'wake up' after shut down to execute tasks every day or on a certain day. It can sometimes be found in the 'Power Management' section of a motherboard's BIOS/UEFI setup. Wake On LAN, Wake on ring, and IPMI functions could also be used to start a computer after it is ...
IEC 60417-5008, [7] the power-off symbol (circle) on a button or toggle, indicates that using the control will disconnect power to the device. (0 or means off.) IEC 60417-5009, [8] the standby symbol (line partially within a broken circle), indicates a sleep mode or low power state. The switch does not fully disconnect the device from its power ...
Sleep mode (or suspend to RAM) is a low power mode for electronic devices such as computers, televisions, and remote controlled devices. These modes save significantly on electrical consumption compared to leaving a device fully on and, upon resume, allow the user to avoid having to reissue instructions or to wait for a machine to boot.