Search results
Results from the WOW.Com Content Network
The bottom bit of the opcode is used to indicate whether the AVX512 index register is considered a vector of sixteen signed 32-bit indexes (bit 0 not set) or eight signed 64-bit indexes (bit 0 set) The instructions all support operation masking by opmask registers. The only supported vector width is 512 bits.
Instruction set extensions that have been added to the x86 instruction set in order to support hardware virtualization.These extensions provide instructions for entering and leaving a virtualized execution context and for loading virtual-machine control structures (VMCSs), which hold the state of the guest and host, along with fields which control processor behavior within the virtual machine.
The x86 instruction set has several times been extended with SIMD (Single instruction, multiple data) instruction set extensions.These extensions, starting from the MMX instruction set extension introduced with Pentium MMX in 1997, typically define sets of wide registers and instructions that subdivide these registers into fixed-size lanes and perform a computation for each lane in parallel.
existing instructions extended to a 64 bit operand size (remaining instructions) Most instructions with a 64 bit operand size encode this using a REX.W prefix; in the absence of the REX.W prefix, the corresponding instruction with 32 bit operand size is encoded. This mechanism also applies to most other instructions with 32 bit operand size.
The FMA instruction set is an extension to the 128 and 256-bit Streaming SIMD Extensions instructions in the x86 microprocessor instruction set to perform fused multiply–add (FMA) operations. [1] There are two variants: FMA4 is supported in AMD processors starting with the Bulldozer architecture. FMA4 was performed in hardware before FMA3 was.
x86-64 (also known as x64, x86_64, AMD64, and Intel 64) [note 1] is a 64-bit extension of the x86 instruction set architecture first announced in 1999. It introduces two new operating modes: 64-bit mode and compatibility mode, along with a new four-level paging mechanism.
In the original SSE instruction set, conversion to and from integers placed the integer data in the 64-bit MMX registers. SSE2 enables the programmer to perform SIMD math on any data type (from 8-bit integer to 64-bit float) entirely with the XMM vector-register file, without the need to use the legacy MMX or FPU registers.
The REX prefix provides additional space for encoding 64-bit addressing modes and additional registers present in the x86-64 architecture. Bit-field W changes the operand size to 64 bits, R expands reg to 4 bits, B expands r/m (or opreg in the few opcodes that encode the register in the 3 lowest opcode bits, such as "POP reg"), and X and B ...