Search results
Results from the WOW.Com Content Network
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
In Western Australia, the narrow-gauge iron ore railways serving Geraldton port and the new port at Oakajee will be designed for ease of conversion to standard gauge. [5] [needs update] 1,435 mm (4 ft 8 + 1 ⁄ 2 in) 1,600 mm (5 ft 3 in) 2016–present Australia Victoria
The Birmingham gauge ranges from 5/0 or 00000, the lowest gauge number corresponding to the largest size of 0.500 inches (12.7 mm), to 36, the highest gauge number corresponding to the smallest size of 0.004 inches (0.10 mm). The increments between gauge sizes are not linear and vary. [2]
Track gauge conversion is the changing of one railway track gauge (the distance between the running rails) to another. In general, requirements depend on whether the conversion is from a wider gauge to a narrower gauge or vice versa, on how the rail vehicles can be modified to accommodate a track gauge conversion, and on whether the gauge conversion is manual or automated.
For the limiting case of a very wide duct, i.e. a slot of width b, where b ≫ a, and a is the water depth, then D H = 4a. For a fully filled duct or pipe whose cross-section is a convex regular polygon , the hydraulic diameter is equivalent to the diameter D {\displaystyle D} of a circle inscribed within the wetted perimeter .
The conversion factor k was chosen so that the values for C were the same as in the Chézy formula for the typical hydraulic slope of S=0.001. [9] The value of k is 0.001 −0.04. [10] Typical C factors used in design, which take into account some increase in roughness as pipe ages are as follows: [11]
For pipe sizes of NPS 14 inch (DN 350) and greater the NPS size is the actual diameter in inches and the DN size is equal to NPS times 25 (not 25.4) rounded to a convenient multiple of 50. For example, NPS 14 has an OD of 14 inches or 355.60 millimetres, and is equivalent to DN 350.
Both pipe and tube imply a level of rigidity and permanence, whereas a hose is usually portable and flexible. A tube and pipe may be specified by standard pipe size designations, e.g., nominal pipe size, or by nominal outside or inside diameter and/or wall thickness. The actual dimensions of pipe are usually not the nominal dimensions: A 1-inch ...