Search results
Results from the WOW.Com Content Network
Two-inch port tube installed in the top of a Polk S10 speaker cabinet as part of a DIY audio project. This port is flared. Unlike closed-box loudspeakers, which are nearly airtight, a bass reflex system has an opening called a port or vent cut into the cabinet, generally consisting of a pipe or duct (typically circular or rectangular cross section).
A transmission line loudspeaker is a loudspeaker enclosure design which uses the topology of an acoustic transmission line within the cabinet, compared to the simpler enclosures used by sealed (closed) or ported (bass reflex) designs.
These designs can be considered a mass-loaded transmission line design or a bass reflex design, as well as a quarter wave enclosure. [39] Quarter wave resonators have seen a revival as commercial applications with the onset of neodymium drivers that enable this design to produce relatively low bass extensions within a relatively small speaker ...
The term loudspeaker may refer to individual transducers (also known as drivers) or to complete speaker systems consisting of an enclosure and one or more drivers.. To adequately and accurately reproduce a wide range of frequencies with even coverage, most loudspeaker systems employ more than one driver, particularly for higher sound pressure level (SPL) or maximum accuracy.
While most studio monitor speakers are either ported bass reflex designs, or closed-back without a vent or passive radiator, Mackie's HR824 and HR624 monitor speakers have a passive radiator installed on the rear of the cabinet. Focal also sells a studio monitor with a passive radiator called the SM9.
The auditory threshold is taken to be 10 –12 W/m 2 (which corresponds to a pressure level of 20×10 −6 Pa). Therefore a speaker with 100% efficiency would produce an SPL equal to 10log(0.159155/10 –12), which is 112.02 dB. The SPL at 1 metre for an input of 1 watt is then: dB (1 watt) = 112.02 + 10·log()
A cabinet with two 10" speakers may be called a "210". Another abbreviation that is used is to add the wattage to the name, so a 500-watt Yamaha combo amp with two 12" speakers may be called the "Yamaha 212-500". In some genres, bass players use a large number of speaker cabinets for a powerful onstage sound.
A typical configuration of a bass-managed 5.1-channel surround-sound loudspeaker system is shown in the first diagram. [5] [6] As shown in the bass management block diagram, a 5.1-channel audio system consists of five discrete, full-range main channels (front left, center, front right, surround left, and surround right), plus a band-limited low ...