Search results
Results from the WOW.Com Content Network
This block is one of three displacements, 302/327/350, that underwent a crankshaft bearing diameter transformation for 1968 when the rod-journal size was increased from the 2 in (50.8 mm) diameter small-journal to a 2.1 in (53.3 mm) large-journal and a main-journal size that was increased from 2.3 in (58.4 mm) to 2.45 in (62.2 mm).
Even with the benefit of today's technology (aftermarket rods and stroker cranks), the upper limit of a Y-block is about 348 cu in (5.7 L), while the Chevrolet could be modified well past the factory limit of 400 cu in (6.6 L). The result was the introduction in 1958 of the 332 CID "big block" Ford FE engine which ultimately grew to 428 cu in
The J-2 engine also had a slightly thinner head gasket, raising compression to 10.0:1. It was advertised with gross power and torque ratings of 312 hp (233 kW) at 4600 rpm and 415 lb⋅ft (563 N⋅m) at 2800 rpm. Oldsmobile charged $83 for the J-2 option with the three-speed manual (or in the 98), [7] $314 with the automatic. [8]
The 350 cu in (5,735 cc) B engine was, along with the 361, the first production B engine, first available in 1958. It had a bore of 4 + 1 ⁄ 16 in (103 mm; 4.06 in). The 350 is classified as a big-block engine. All parts except for the pistons are fully compatible with the 361. Vehicles using the B 350: 1958 DeSoto Firesweep; 1958 Dodge Coronet
The Chevrolet small-block engine refers to one of the several gasoline-powered vehicle engines manufactured by General Motors.These include: The first or second generation of non-LS Chevrolet small-block engines
Shrink-fitting is a technique in which an interference fit is achieved by a relative size change after assembly. This is usually achieved by heating or cooling one component before assembly and allowing it to return to the ambient temperature after assembly, employing the phenomenon of thermal expansion to make a joint. For example, the thermal ...
Although the engine is an outgrowth of the Gen-2 V8, these changes cause it to be regarded as the third generation of AMC V8, or "Gen-3". The stroke and deck height on the 290 and 343 were increased by 0.16 in (4.06 mm) on both engines, becoming the 304 cu in (5.0 L) and 360 cu in (5.9 L), respectively.
The two-valve arrangement is retained, though the titanium intake valves by Del West have grown to 2.2 in (56 mm) and sodium-filled exhaust valves are up to 1.61 in (41 mm). Peak output is 505 bhp (512 PS; 377 kW) at 6300 rpm (72.0 BHP/L) and 470 lb⋅ft (637 N⋅m) of torque at 4800 rpm with a 7000 rpm redline. [ 68 ]