Search results
Results from the WOW.Com Content Network
A disk sector (7) on a floppy diskette. A 3.5 inch 1.44MB mini-floppy diskette contains 80 tracks, 18 sectors per track, and 512 bytes per sector. A 3.5 inch 720k diskette contains 80 tracks, 9 sectors per track, and 512 bytes per sector. This technique refers to formatting an 80-track 1.44MB diskette as a special 40-track 720KB diskette.
3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
FlashPath is hardware compatible with all standard 3.5" High-Density Floppy disk drives, but is not a drop-in replacement for real floppy disks. A special software device driver must be installed on the computer that is to access data via FlashPath. Thus, FlashPath is only usable with computers and operating systems for which such a driver ...
A typical floppy disk controller sends an MFM / FM / GCR encoded signal to the drive to write data, and expects a similar signal returned when reading the drive. [6] On a write, a hardware PLL or a software-based filter component undoes the encoding, and stores the sector data as logically written by the host. An inverse mechanism translates ...
Zip drive (floppy-like, but incompatible medium using different technology) PocketZip (floppy-like, but incompatible medium using different technology) SuperDisk (floppy-like with drives also compatible with 3.5" floppy disks) Magneto-optical drive (floppy-like, but incompatible medium using different technology)
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.
An internal floppy drive and controller are required as well; USB floppy drives operate strictly at the file system level and do not allow low-level disk access. [9] The WD1770 controller chip, however, was the seat of some early problems with 1581 drives when the first production runs were recalled due to a high failure rate; the problem was ...