Search results
Results from the WOW.Com Content Network
Baylè 1879 wallet / palm pistol France: 1879 COP .357 Derringer.38 Special.357 Magnum United States: 1983 Pepper-box: 1700s-1800s Garrucha (pistol).32 S&W.38 S&W.22 Short.22 Long.22 Long Rifle Brazil: 1930s Howdah pistol.577 Snider.455 Webley.476 Enfield United Kingdom: 1800s-1900s Lancaster pistol.577 inch.450 Adams.455 Webley United Kingdom
The pick is then used to lift each lever inside the lock to the correct height so that the locking bolt can pass. Higher security lever locks (such as the five-lever) usually have notches cut into the levers. These catch the locking bolt and prevent it from moving if picking is attempted (similar to the security pins in a pin tumbler lock).
[3] [4] [5] More specifically, it refers to the mechanism or lock of such firearms. It may also refer to a gun's lock which uses slow match to ignite the powder charge. [6] [7] The matchlock was a lever mechanism that simplified the ergonomics of firing. Slow match would be held clear of the flash pan in a spring-loaded pivoting arm (the ...
Again, the term refers to the lock mechanism, so a lock can be both a mortise lock and a lever tumbler lock. In the modern lever tumbler lock, the key moves a series of levers that allow the bolt to move in the door. [5] Pin tumbler lock, commonly used for mortise locks in the US. The next major innovation to mortise lock mechanisms came in 1865.
This 6-shot, .357 Magnum revolver uses a unique interchangeable barrel system, including a 2.5 in (64 mm) snub nose barrel along with 4 in (100 mm), 6 in (150 mm), 8 in (200 mm), 10 in (250 mm), 12 in (300 mm), and 15 in (380 mm), partial or fully-lugged shrouds with choices of solid or ventilated ribs, plus removable and interchangeable front ...
An unusual element in this design is a three-armed "barrel-holding lever". It is pivoted above the trigger as shown in the drawing from page 188, Mannlicher Rifles and Pistols, Smith, 1947. Its bottom arm engages with the trigger. The forward arm holds the barrel forward for loading. The rear arm serves as a hammer catch.
It was produced in a single item product with a 2-5/8" barrel. The Cloverleaf Model was more produced by far, and had two different variants, depending on the barrel length: 1-1/2" and 3". The 1-1/2" barrel length variant had an ejector rod contained within the center pin of the cylinder, allowing to reload while keeping the cylinder in the gun.
It was the second all stainless steel revolver made by Smith & Wesson, the first being the Smith & Wesson Model 60. [1] It was widely used by several U.S. police, sheriff and state agencies and was a popular choice in high humidity states because the stainless model 64 was more corrosion and rust resistant than the blued Model 10.