Search results
Results from the WOW.Com Content Network
Because nickel-plated Merwin and Hulbert pistols had the same cost as those without, it is rare to find Merwin and Hulbert revolvers with a blued finish. A key innovation was a rotating barrel design which allowed the user to rotate the barrel 90 degrees in order to pull the barrel and cylinder forward to remove the fired cartridge cases.
Not all cavalry used this method of draw, or located their holsters on the right hand side of the body. In the "Manual of Arms for the Sharps Rifle, Colt Revolver and Swords (1861)", [1] which was used by the Union Army, the revolver would have been worn on the left side, in front of the sabre-hook. To draw the revolver, the soldiers were ...
Available barrel lengths are 2.5 inches (64 mm), 3 inches (76 mm), 4 inches (100 mm), 4.2 inches (110 mm), 5 inches (130 mm), and 6 inches (150 mm) with partial or full length underlugs. [3] Blued steel or stainless steel finishes are available, with stainless model numbers preceded by a "K". The firing pin of the GP100 is mounted inside the frame
The pick is then used to lift each lever inside the lock to the correct height so that the locking bolt can pass. Higher security lever locks (such as the five-lever) usually have notches cut into the levers. These catch the locking bolt and prevent it from moving if picking is attempted (similar to the security pins in a pin tumbler lock).
This 6-shot, .357 Magnum revolver uses a unique interchangeable barrel system, including a 2.5 in (64 mm) snub nose barrel along with 4 in (100 mm), 6 in (150 mm), 8 in (200 mm), 10 in (250 mm), 12 in (300 mm), and 15 in (380 mm), partial or fully-lugged shrouds with choices of solid or ventilated ribs, plus removable and interchangeable front ...
It was produced in a single item product with a 2-5/8" barrel. The Cloverleaf Model was more produced by far, and had two different variants, depending on the barrel length: 1-1/2" and 3". The 1-1/2" barrel length variant had an ejector rod contained within the center pin of the cylinder, allowing to reload while keeping the cylinder in the gun.
Two Colt Model 1851 Navy revolvers with same caliber and a Colt Root Model 1855 rifle, .36 cal. Colt Root carbines, .56 cal. The design of the Colt revolving rifle was essentially similar to revolver-type pistols, with a rotating cylinder that held five or six rounds in a variety of calibers from .36 to .64 inches. [1]
In 1860, the .36 caliber Police Pocket model was created, after lessons were learned from experimentation aimed at reducing the size of the .44 Colt Holster Pistols (i.e. large cavalry weapons), Colt took advantage of stronger mass-produced steel by rebating the frame of the Navy revolver to hold a larger-diameter 44/100-inch chambered cylinder ...