Search results
Results from the WOW.Com Content Network
A flitch beam (or flitched beam) is a compound beam used in the construction of houses, decks, and other primarily wood-frame structures. Typically, the flitch beam is made up of a vertical steel plate sandwiched between two wood beams, the three layers being held together with bolts .
A flitch beam is a simple form of composite construction sometimes used in North American light frame construction. [3] This occurs when a steel plate is sandwiched between two wood joists and bolted together. A flitch beam can typically support heavier loads over a longer span than an all-wood beam of the same cross section.
Historically a beam is a squared timber, but may also be made of metal, stone, or a combination of wood and metal [1] such as a flitch beam.Beams primarily carry vertical gravitational forces, but they are also used to carry horizontal loads such as those due to earthquake or wind, or in tension to resist rafter thrust or compression (collar beam).
The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...
A beam supported at its Airy points has parallel ends. Vertical and angular deflection of a beam supported at its Airy points. Supporting a uniform beam at the Airy points produces zero angular deflection of the ends. [2] [3] The Airy points are symmetrically arranged around the centre of the length standard and are separated by a distance equal to
Re-sawing is the splitting of 1-to-12-inch (25–305 mm) hardwood or softwood lumber into two or more thinner pieces of full-length boards. For example, splitting a 10-foot-long (3.0 m) 2×4 (1 + 1 ⁄ 2 by 3 + 1 ⁄ 2 in or 38 by 89 mm) into two 1×4s (3 ⁄ 4 by 3 + 1 ⁄ 2 in or 19 by 89 mm) of the same length is considered re-sawing.
A Florida man is accused of stabbing his estranged girlfriend up to 70 times during a fatal break-in - exactly one month after he was nabbed for assaulting the victim and ordered to stay away from ...
1570 Palladio presents truss-beam constructions with diagonal beams to prevent shear deformations. 1638 Galileo Galilei describes the efficiency of tubes versus solid rods. 1652 Wendelin Schildknecht reports about sandwich beam structures with curved wooden beam reinforcements.