Search results
Results from the WOW.Com Content Network
The standard wiring colours in the UK are (as of 2006) the same as elsewhere in Europe and follow international standard IEC 60446. This colour scheme had already been introduced for appliance flexes in the UK in the early 1970s, however the original red/black colour scheme recommended by the IEE for fixed wiring was retained until 2006, albeit ...
Note that the wires in the 6-wire cable are coloured with two colours in a ratio of four to one in length, with the first colour mentioned being the predominant one, e.g. if the indicated colour of the wire is W-B then the wire will be coloured white for 12 mm, then blue for 3 mm and so on.
The term plug is in general and technical use in all forms of English, common alternatives being power plug, [3] electric plug, [4] and plug top. [5] The normal technical term for an AC power socket is socket-outlet, [6] but in non-technical common use a number of other terms are used.
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...
The type 11 plug is unearthed, with two 4 mm diameter round pins spaced 19 mm apart. The type 12 plug adds a central 4 mm diameter round earth pin, offset by 5 mm. The type 12 socket has no recess, while the type 13 socket is recessed. Both sockets will accept type 11 and type 12 plugs, and also the 2.5 A Europlug.
Die-Cut Plug Wiring Diagram Book is an artist's book by the English artist Mark Pawson, originally published in early 1992. [1] Originally consisting of 36 full-size reproductions of British AC power plug wiring diagrams printed in various colours, the book has become celebrated as an example of English sociological art , and is sometimes ...
The cable core colours are described in IEC 60304 (1982-01), Standard colours for insulation for low- frequency cables and wires. The three-phase phase colours are brown, black and grey instead of red, yellow and blue. Where a circuit includes a neutral or mid-point conductor identified by colour, the colour used shall be blue.
Older Bell System wiring inside customer premises used untwisted wire cable, with each conductor a different solid color. 4-conductor was most common, but 6-conductor was sometimes used and the colors for up to 5 pairs (10 conductors) were defined. They correspond to the current 25-color code as follows: